. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . About this Site Preparation Guide
About this Site Preparation Guide
This document is intended for service technicians. It contains site preparation requirements and instructions for installing a
Customer Responsibilities
The following list describes some of the items and equipment you must provide, plus the facility preparations you must complete before installing a
•Provide a site drawing that shows the location of the following:
•Equipment currently installed at the site and the area designated for the
•Existing site wiring (power, signal paths, and lengths)
•Equipment capable of generating electrical noise, electromagnetic interference, and heat
•Provide and install the following items:
•Required communications cables, wall jacks, special connectors, and associated hardware
•
•
Necessary power distribution boxes, conduits, grounds, lightning protection, and associated hardware (see "Power Requirements" on page 10)
Required auxiliary power or other equipment
•
•
Make building alterations necessary to meet wiring, environmental, and other site requirements
Make sure all site construction, wiring, or other alterations meet applicable codes, regulations, and laws (including, but not limited to, electrical, building, safety, and health)
•
•
Provide necessary storage and service areas (see "Environmental Requirements" on page 9)
Provide floor coverings and environmental systems that limit or control electricity
| 1 |