Niles Audio RCA3 specifications Locating IR Sensor

Page 8

R E M O T E C O N T R O L A N Y W H E R E ! K I T

Step 4 – Mounting a MicroFlasher to A/V Components Make sure all of your remote controls have batteries and that they are able to operate the A/V components.

Locate a place for the remote control that is within arm’s length of the A/V components, yet cannot directly control them. Place the table-top sensor no closer than two feet in front of the remote control (Figure 6).

Hold the MicroFlasher four inches in front of the remote sensor window on the A/V compo- nent’s front panel. Press but- tons on the remote control while watching the front panel of the A/V compo- nent. When the compo-

nent responds repeatedly to the commands, peel off the protective backing on the MicroFlasher and place the MicroFlasher in that location.

If the A/V component’s remote sensor is not clearly marked, slowly move the MicroFlasher over the win- dow of the A/V component while pushing buttons on the remote control until you get a response (Figure 7).

Figure 6:

Locating IR Sensor

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents RCA3 Kit Contents IntroductionTools Needed Installation Getting StartedConnecting the Sensor Cable to Connection Hub MSU250 InstallationRed = 12V+ Black = Ground Yellow = Data White = Status Connecting the 12VDC In-Line Power Supply and MicroFlashers Tech TIPLocating IR Sensor Once you have decided on the ideal location for Wall-mount placement Running the Sensor Cable Reconnecting the Connection Hub ConnectingNormal Operation Optional Accessories Status Feedback Wall AdapterAdditional Sensors Running Sensor Cable in New Construction Scheduling and PreparationSafety First DrillingConcealing Sensor Cable in Existing Walls Pulling the CableM O T E C O N T R O L a N Y W H E R E ! K I T M O T E CA N Y W H E R E ! K I T Routing Wire Around a Door Specifications MSU250 MS200Niles Audio Corporation Remote Control Anywhere! Kit
Top Page Image Contents