Omnimount Lift 42 manual ƒ Attach the Universal Adapter to the TV

Page 15

Step 8

ƒAttach the Universal Adapter to the TV:

•Place the TV face down on a protected surface.

•For larger TV’s, the vertical rails may need swapped out for the longer included rails. Rails are swapped by removing 2 Phillips screws per rail.

•Use the self center function of the adapter to line up the TV’s mounting holes with the slots in the vertical rails. Connect the TV to the adapter using the correct screws (M-A – M-L) and square washers (U). Spacers (M-M and M-N) may be needed if the TV has recessed mounting holes or if inputs are obstructed by the mount. IF SPACERS ARE REQUIRED, THE INSIDE DIMENISIONS OF THE ENCLOSURE MUST ACCOMMODATE THIS NEED!

•DO NOT OVERTIGHTEN HARDWARE, DAMAGE TO THE TV MAY RESULT.

M-A – M-L

M-A – M-L

10

10

11

Note: IF MONITOR SCREWS “BOTTOM OUT”, THEN USE ADDITIONAL WASHERS (not included) TO TAKE UP THE SLACK.

TV

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Lift Ominmount Product Warranty Contents Monitor Kit L-U-vA ƒ Pinch Point Warning Minimum Interior Dimensions Width Depth Height ƒ Attach the Base Bracket 1 to the Lift Column ƒ Attach the Bayonet Bracket 3 to the enclosure Figure a ƒ Secure Lift Column and Base Bracket in enclosureTOP ƒ Connect Screen Adapter 12 to the Screen SupportDWN Before After ƒ Attach lift assembly to enclosure base ƒ Attach the Universal Adapter to the TV ƒ Connect the TV and universal adapter to the lift column ƒ Install universal adapter rail covers ƒ Using guide pins for a floating top Guide Pin/Top Plate Template Thank you for purchasing an OmniMount product
Top Page Image Contents