Install ROPS Brackets
1.Place ROPS bracket (33) under rear axle and secure to ROPS using two cap screws (30) and hardened flat washers (28).
NOTE: Bracket must be orientated with the "short" side towards the outside of the tractor.
2.Repeat for opposite side of tractor.
30.59036 M12 x 1.75P x 150 mm HHCS
28.57816 1/2 Hardened flat washer
33.1022125 ROPS bracket, link
30
33
DP2
Figure 7. ROPS Bracket Installed - Right Side
Install Tractor Brackets
With Woods LS84 Loader Mount
1.Place left tractor bracket (4) under left side of tractor. Use a hydraulic floor jack to help raise and hold tractor bracket in position.
2.Attach left tractor bracket (4) to left loader mount using two cap screws (32), four hardened flat washers (29), and two hex nuts (23).
3.Attach tractor bracket to the bottom of ROPS bracket (33) using four cap screws (26), eight hardened flat washers (28), four hex nuts (21).
4.Place right tractor bracket (3) under right side of tractor. Use a hydraulic floor jack to help raise and hold tractor bracket in position.
5.Attach right tractor bracket (3) to front mount (10) using two cap screws (32), four hardened flat washers (29), and two hex nuts (23).
6.Attach tractor bracket to the bottom of ROPS bracket (33) using four cap screws (26), eight hardened flat washers (28), four hex nuts (21).
3.1022130 Right tractor bracket
4.1022131 Left tractor bracket
10. 1026846 Front mount (LS84 only)
21.1093 1/2 NC Hex nut
23.230 5/8 NC Hex nut
26.3699 1/2 NC x 2 HHCS GR5
28.57816 1/2 Hardened flat washer
29.57817 5/8 Hardened flat washer
32.902 5/8 NC x 2 HHCS GR5
33.1022125 ROPS bracket, link
Figure 8. Tractor Brackets Installed with LC84 Loader
MAN0708 (4/11/2008) | Installation 7 |
|
|