DP6A

Install Tractor Brackets

With New Holland 7308, 110TL Loader Mount or Woods LC96, LC102, 1009, 1012 Loader Mount

1.Place left tractor bracket (4) under left side of tractor. Use a hydraulic floor jack to help raise and hold tractor bracket in position.

2.Attach left tractor bracket to left front mount (9) using two cap screws (32), four hardened flat washers (29), and two hex nuts (23).

NOTE: Tractors equipped with mid-mount mower, place tractor bracket on the inside of front mount as shown in Figure 9. Tractors without mid-mount mower, place on the outside of front mount.

3.Attach tractor bracket to the bottom of ROPS bracket (33) using four cap screws (26), eight hardened flat washers (28), four hex nuts (21).

4.Attach right tractor bracket (3) to front mount (8) using two cap screws (32), four hardened flat washers (29), and two hex nuts (23).

5.Attach tractor bracket to the bottom of ROPS bracket (33) using four cap screws (26), eight hardened flat washers (28), four hex nuts (21).

Figure 9. Left Tractor Bracket Attached to Front Mount with Mid-Mount Mower

3.1022130 Right tractor bracket

4.1022131 Left tractor bracket

8.1026847 Right front mount

9.1013475 Left front mount

21.1093 1/2 NC Hex nut

23.230 5/8 NC Hex nut

26.3699 1/2 NC x 2 HHCS GR5

28.57816 1/2 Hardened flat washer

29.57817 5/8 Hardened flat washer

32.902 5/8 NC x 2 HHCS GR5

33.1022125 ROPS bracket, link

Figure 10. Tractor Bracket Installation with OEM and Woods LC96, LC102, 1009, 1012 Loaders

8 Installation	MAN0708 (4/11/2008)