Technicolor - Thomson EU2845ST Double-digit, Personal Preferences PP, Sound Indicator, Volume Bar

3) Double-digit (- -)

This OSD is displayed when the "Double-Digit" button pressed in place of the programme number indicator.

After then, in order to enter a programme it must be pressed to two digit consecutively. When it is late to press any digit button this function will be ignored and the display will be erased. In the same way it must not be late to press any digit button after entering the first digit. The limit of the delay time is 3 seconds.

4) Personal Preferences (PP)

All the preset values will be restored, when pressing "PP".

5) Sound Indicator

This is a stereo option. The alternatives of the indicator are Mono, Stereo, Dual-I and Dual-II. This indicator is displayed under the programme number indicator on the screen. "I-II" button is used to select Mono, Ste- reo, Dual-I or Dual-II.

In Mono broadcast or in forced-mono (for stereo broad- cast).

In Stereo broadcast.

If dual broadcast detected. Dual-I is selected in default and also can be selected after Dual-II by Remote Con- trol.

'8$/￿,

If Dual-II selected by Remote Control.

6) Picture Mode

The picture mode OSD is displayed below the sound indicator, by TV Status OSD’s. According to the WSS data, inside of the OSD box “4:3” , “16:9”, “CINEMA”, “SUBTITLE”, “ZOOM” or “AUTO” is written.

By pressing “” (TXT_UPDATE) button (if Teletext is not active) the picture mode can be switched into 4:3, 16:9, CINEMA, SUBTITLE, ZOOM or AUTO Mode.

7) Blue Background During No-Signal

In case, no valid signal is detected (in TV or AV mode) Blue Background is activated. During search process Blue Background is not active. But instead of it there is another feature given; the semi-transparent menu background is made blue.

8) Mute Indicator

It is placed in the upper middle of the screen when en- abled, and it stays there until it is disabled.

To cancel mute, there is two alternative; the first one is

pressing to "" button, thus volume is set to the pre- ceding value, and the second one is increasing the vol- ume level, thus it starts at the minimum level to in- crease. By decreasing the volume level in mute state, mute will not be ignored, only the volume level will de- crease. If mute canceled after decreasing the volume level, the volume will valid with the decreased level.

9) Volume Bar

It is displayed in the lower middle of the screen. When

avolume command is received (pressing “-” or “+” by Remote Control or Front panel) and no menu is active, it stays on the screen for 3 seconds, after the last volume command or until another com- mand is received in between.

10) AV Modes

By pressing the “$9“ button you can switch your TV to AV modes (except being in Teletext). Pressing this button will switch the TV in one of the optional AV modes: EXT-1, RGB, YCbCr and F-AV (Front AV). EXT-1 supports the RGB mode.

In order to quit the AV mode press the “79”, digit but- tons or “-P/CH” or “P/CH+”.

ENGLISH - 17 -

EU2845ST&2845W-MAV-1541-ENG-STEREO-17AK45.p65 09.09.2003, 10:54