Technicolor - Thomson ETC210 specifications Using remote control for other equipment RC 311TAM1

ETC210_en 2/05/03 17:51 Page 5

Using remote control for other equipment (RC 311TAM1)

This remote control is supplied with some TV sets models, it can operate other equipment, such as video recorders, DVD players, satellite receivers or hi-fi systems.This page provides information concerning the remote control’s use with these other types of equipment.

Video recorder	DVD player	Programming the remote control
		Automatic code search
		This method can be used to automatically find the
Press VCR button	Press DVD button	most appropriate code for your appliance.		EN
		1. Switch on the appliance you wish to use the
On/Standby		remote control with.
		2. Press the relevant button for this appliance on the
		remote control, and while holding this button
To display the main	To display the main	down, press the	standby button until	the
menu.	menu.	remote control light comes on. Release the two
		buttons.
Vertical scrolling in menus
		3. Point the remote control at the appliance and
Horizontal scrolling in menus		press PLAY.Wait until the light stops flashing. If the
		appliance has not gone into standby mode after
To confirm an action.		five seconds, press the PLAY button again to
		continue the search for the next set of codes.
To close a menu.		Repeat this operation until the appliance goes into
		standby mode.There are 20 sets of codes.
To directly access	To enter numeric values	4. When the appliance goes into standby mode, press
channels or enter	or select options in
numeric values.	menus.	the standby button on the front to switch it on
		again.Then press the REV button to put it back in
Changement de chaîne		standby mode, and if necessary, keep pressing until
		the appliance goes into standby.
Sélection de l’entrée AV
Rewind	Rewind	5. Press the STOP button and hold it down until the
		remote control light goes off.
Play	Play
Fast forward	Fast forward
Stop	Stop	Note: you can cancel the programming operation at any
Pause	Pause
		time by pressing the EXIT button.
Only makes of apparatus of the THOMSON group benefit from the actions of all the
buttons

Manual programming

This method involves carrying out a manual search for the codes to be used for controlling your other appliances.

1.Switch on the appliance you wish to use the remote control with.

2.Press the relevant button for this appliance on the remote control, and while holding this button down, enter one of the codes relevant to your make of appliance (there is a list of codes at the end of this manual). If the remote

control light flashes you have entered the wrong code or it is not possible to program the remote control.

3.Point the remote control at the appliance and press the relevant button (VCR or DVD). Press the If the appliance does not go into standby mode, try another code.

Depending on the year of manufacture and the type of appliance, some functions may not be available.

standby button.

Certain codes may cover more functions than others.Test the functions you can control and, if appropriate, try other codes.

VCR

Note here the code(s) which work best.

DVD/LD

When you change the remote control’s batteries, remember to reprogram it.

5