Yamaha DVD-S559 owner manual Connecting using the component video output, Interlace, Standby/On

Connecting up

		S-VIDEO
		IN
TV
	PB/CB	VIDEO
PCM/q DIGITAL		L
/DTS/MPEG
COAXIAL		R
	PR/CR	Y
DIGITAL OUT	S VIDEO	COMPONENT
	VIDEO OUT	AUDIO OUT

Connecting using the component video output

You can use the component video output instead of the standard video out jack to connect this player to your TV (or other equipment). This should give you the best quality picture from the three types of video output available.

•Use a component video cable (not supplied) to connect the COMPONENT VIDEO OUT jacks to a component video input on your TV, monitor or AV receiver.

		COMPONENT
		VIDEO IN
TV
	PB/CB	VIDEO
PCM/q DIGITAL		L
/DTS/MPEG
COAXIAL		R
	PR/CR	Y
DIGITAL OUT	S VIDEO	COMPONENT
	VIDEO OUT	AUDIO OUT

02

Watching progressive scan video from the component video outputs

This player can output progressive scan video	English
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see Video Output settings on page 31.
When the player is set to output progressive
scan video, the PRGSVE indicator lights in the
front panel display.

Important

•If you connect a TV that is not compatible with a progressive scan signal and switch the player to progressive, you will not be able to see any picture at all. In this case, switch everything off and reconnect using the supplied video cable (see Easy connections on page 8), then switch back to Interlace (see below).

Switching the video output to interlace using the front panel controls

Switch the player to standby then, using the front panel controls, press STANDBY/ON

while pressing to switch the player back to

Interlace.

STANDBY/ON

DVD-S559

10

En