Grizzly G1014ZX owner manual Order Of Assembly Stand

SECTION 4: ASSEMBLY

Order Of Assembly Stand

Most of your Combination Sander has been assembled at the factory. The few remaining pieces will go together quickly and should be done in the following order:

1.Stand

2.Mounting Sanding Unit

3.Attaching the Back Stop

4.Attaching Sanding Disc

5.Mounting the Work Table

Note: All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is removed at the factory. Sometimes, though, a bit of flashing might escape inspection. Please examine the edges of all die-cut metal parts before handling them.

TOOLS REQUIRED: Only a few common tools are required to assemble your Combination Sander. Specifically, these are: 6" adjustable wrench, 12mm open end wrench, regular screw- driver, Phillips screwdriver, and a 4mm Allen wrench.

The G1014Z Combination Sander stand is an open frame style. The four legs are connected with top and bottom cross braces.

1.Attach Rubber Feet to base using the four 5⁄16''-18 x 1'' Hex bolts, Hex Nuts and Flat Washers provided. Figure 2.

Figure 2.

-8- G1014Z Combination Sander