Vertical Positioning
The 6" belt arm can also be operated in a vertical position. Adjustment procedures are listed below.
1.Loosen the two nuts shown in Figure 16 (one nut is obscured by the belt arm in this photo but it is directly below the visible one). With these nuts loose, the belt frame can be raised to its vertical position. Tighten the nuts down.
Figure 16.
2.The Sanding Disc Table can also be moved to become a work table for belt sanding. Simply remove the Table Support Shaft from the base and insert it into the mounting bracket behind the motor. The Bracket’s location is shown in Figure 17.
Figure 17.
Figure 18. Setup for vertical sanding.
G1014Z Combination Sander |