Panasonic PV-C2063A To Clear program, Desired program, To exit this mode, Repeat steps 1 and 2 on

*Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again.

Cancel a Timer Recording: (Recording is in progress)

Hold down STOP for a few seconds to cancel the Timer Recording.

•Any future daily or weekly recordings will be performed as programmed.

SELECT/SET

:CH UP

:CH DOWN

:VOL UP :VOL DOWN

PROG

ADD/DLT

STOP

Review, Replace or Clear Program
Contents :						(Recording is not in progress)
1 Repeat steps 1 and 2 on page 22.
2		P DT		STA R T		STO P	CH	S PD	Press	to select
		1	day	9	: 00p 12 : 00a		08	SP	the desired program.
		2	8	10: 00a		12 : 00p 125		SP
	3		10	8 : 00p		9 : 00p	10	SP
	4		S U	9	: 00p	10: 00p	L	LP
		C AN C EL			: A DD /DLT
		SELECT			1 -8 :
		E NTER			:
		END			: P R O G /AC TI ON

To Replace program						...
3 DA			TE	S TART	S TOP	CH	1)Press		to display.
	8 SAT			9 :00P	12 :00A 08		2) Press		to select
	TO	D A Y				ABC	and	press	or
						SP
----------------------------------------------
							to set new program
	SE LE C T START				D ATE
	SELE C T:
							contents.
	SET			:
	END			: P R O G /ACT I ON			3)Press PROG		(or
							ACTION		).

To Clear program...

1 -- --: ---: -- -- -- Press ADD/DLT								.
P DT		STA R T		STO P		CH	S PD
2	8	10	: 00p	12	: 00a 125		SP
3	10	8	: 00p	9	: 00p	10	SP
4	S U	9	: 00p	10	: 00p	L	LP
SELECT			1 -8 :
E NTER			:
END			: P R O G /AC TI ON

4	Press PROG	twice (or ACTION	)
	to exit this mode.
Notes
• 2	minutes before Timer	recording is performed,

“PLEASE PREPARE FOR TIMER REC” appears and/ or the PROG TIMER Indicator flashes. Be sure a cassette with record tab is loaded and the unit is in Stop mode.

•If the start times of two programs overlap, the lower numbered program will have priority.

•If the start time for a Timer Recording comes up during a normal recording or One Touch Recording (page 12), the Timer Recording will not be performed.

•If there is a power interruption of more than one minute, the recording may not be performed or continued.

•If “INCOMPLETE” appears after all items have been set, check all entries and make necessary corrections.

Timer Operation

23