Panasonic PV-C2063A operating instructions Manual Clock Set, Play

*Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again.

Manual Clock Set

If AUTO CLOCK SET was incomplete, manually set the clock as follows.

	Press ACTION							on the remote to
1 display SET CLOCK Menu screen.
							SET	C LOC K
				1 /		/	:
									DST : O N
			SE	LE C T M O N TH
			SE			LE C T:
			SET				:
			END				: ACT	I O N
2	Press	press					to select the month
	and						to set. In the same
	manner, select and set the date,
	year, time, and DST. (Daylight
	Saving Time)
							SET	C LOC K
				2 /			6/2002	WED 12 :00PM
									DST : O N
			SE TCOMPLETED
			SET				:
3			START				: ACT I O N
	Press ACTION							twice to start

CLOCK and exit.

POWER
	SELECT/SET
	:CH UP
ACTION	:CH DOWN
	:VOL UP
	:VOL DOWN

Reset all unit Memory Functions

When moving unit to a new location, or if a mistake was made in the Initial Setup section.

• Make sure a tape is not inserted in the unit.

1 Turn the unit Power on.

2	Press and hold both	PLAY	and
	FF on the unit for more than 5

seconds.

•The power will shut off.

•Please ignore “NO CASSETTE” warning.

3 Do “Initial Setup” on page 8.

Note to CABLE System Installer

This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be

connected to the grounding system of the building, as close to the point of cable entry as practical.

Initial Setup

9