OTR (One Touch Recording)
TV/VCR
This function enables you to set a recording length simply by pressing the REC/OTR button on the TV/VCR/DVD.
Make sure ...
•TV/VCR/DVD power must be turned on.
•Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)
NOTES:
• This function CANNOT be done from the remote control.
• Recording starts immediately when the REC/OTR button is pressed.
• When the REC/OTR button is pressed 18 times, the TV/VCR/DVD returns to the Normal Recording mode.
• To stop the OTR operation, press the STOP button on the TV/VCR/DVD or on the remote control.
• To show the remaining time, press the DISPLAY button on the remote control so that “OTR” appears on the TV screen. (It will show up momentarily then disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum record- ing time, assuming the tape is started at the begin- ning, is 8 hours using
• If the tape runs out before the end time, the TV/VCR/DVD will switch to the Stop mode immediately, ejects the tape and turns itself off.
• If you press the POWER button during OTR, the TV/VCR/DVD continues recording until the select- ed length is reached.
1 Select the channel to be recorded
Press the number buttons on the remote control or the CHANNEL button K or L.
Remember: If the TV/VCR/DVD is connected to a cable box or satellite box, the TV/VCR/DVD must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box.
Push(es) | Display |
| Recording length |
1 push |
| (normal recording) | |
2 pushes | 0:30 |
| 30 minutes |
|
|
|
|
3 pushes | 1:00 |
| 60 minutes |
|
|
|
|
|
|
|
|
17 pushes | 8:00 |
| 480 minutes |
|
|
|
|
COPYING A VIDEO CASSETTE (Requires a VCR or camcorder)
TV/VCR
You can make copies of video tapes made by friends or relatives for your enjoyment.
You can not copy a DVD to a videotape.
WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.
Connect your TV/VCR/DVD and a Source (Playing) VCR using the following diagram.
[The TV/VCR/DVD] | [Fig.8] | |
| [Ex: Source (playing) | |
Audio/Video | VCR or camcorder] | |
AUDIO | ||
adapter cable | L | |
OUT IN | ||
(not supplied) | R | |
VIDEO | ||
| ||
| OUT IN |
1)Insert a
2)Insert a blank video cassette, or one you want to record over, into the TV/VCR/DVD’s cassette compartment.
3)Press the SPEED button on remote control for the TV/VCR/DVD to select the desired recording speed (SP/SLP).
2Select the tape speed
Press the SPEED button to select the desired tape speed (SP/ SLP).
3Begin OTR
Press the REC/OTR button on the TV/VCR/DVD as many times as needed. The recording length will be determined by the number of times you press the REC/OTR button. Each SP additional push will increase the
recording time by 30 minutes. It is set up to 8 hours.
4)Press the CHANNEL button K or L on the TV/VCR/DVD until “AUX” appears on the screen.
5)Press the RECORD button on the TV/VCR/DVD. 6)Begin playback of the tape in the source (Playing)
VCR or camcorder.
NOTE: For best results during copying, use the TV/VCR/DVD’s front panel controls whenever pos- sible. The remote control might affect the source (Playing) VCR’s playback operation.
7)To stop copying, press STOP/EJECT button on the TV/VCR/DVD, then stop the tape on the source VCR or camcorder.
- 31 - | EN |
1C29