Sylvania 6309CD Preparation for USE, ANTENNA/CABLE Connections, VHF/UHF Combined Antenna

PREPARATION FOR USE

	From Cable System or
	Satellite Dish
Satellite Box or
Cable Box	OUT	IN
(Not supplied)

From

Cable System

Dipole Antenna
(Supplied)	VHF/UHF Antenna
	(Not supplied)
Flat twin-lead cable
	VHF Antenna
Matching Adapter	(Not supplied)
(Supplied)	UHF Antenna
or
	(Not supplied)
VHF/UHF
or Combiner
(Not supplied)

75-ohm	ANT.
Coaxial Cable
(Not supplied) or	or	Flat twin-lead cable

ANTENNA/CABLE

CONNECTIONS

DIPOLE ANTENNA HOOK UP

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/VCR without a converter box. By using this connection you can:

1.Push the stem of the Dipole Antenna (supplied) into the hole for antenna at the back of TV/VCR.

2.Connect the flat twin-lead cable from the Dipole Antenna to the 300/75 ohm Matching Adapter (accessory).

3.Plug the Matching Adapter to ANT terminal of TV/VCR as shown in drawing.

For the best reception, extend the Dipole Antenna and adjust its length and position. (Avoid handling the top section when making adjustments.)

NOTE: If it is difficult to get good reception with the indoor antenna, the use of an outdoor antenna is recommended. Before an outdoor antenna is connect- ed to the set, the indoor antenna should be discon- nected.

VHF/UHF COMBINED ANTENNA

A VHF UHF 75 ohm combination antenna can be connected to ANT terminal.

1)Use the TV/VCR remote to select channels.

2)Program one or more unscrambled channels for Automatic Timer Recording.

NOTE: This unit will ONLY record and view the same channel.

CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown in drawing.

By using this connection you can also record scram- bled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/VCR Remote Control. Unattended timer recording is limited to one channel at a time.

TO RECORD A SCRAMBLED/UNSCRAMBLED CHANNEL

VHF/UHF SEPARATE ANTENNAS	1. Set the TV/VCR channel selector to the output
In some areas it will be necessary to use an outdoor	channel of the Cable Converter Box or Satellite Box.
	(Ex. CH3)
antenna.
	2.Select the channel to record from your Cable
	Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect- ed to the grounding system of the building as close to the point of cable entry as practical.

- 9 - EN

9J27