Emerson CETD204 Connecting to External Input Jacks, Installing the Batteries, External Input Mode

TO RECORD A SCRAMBLED/UNSCRAM- BLED CHANNEL

1.Set the TV/VCR/DVD channel selector to the out- put channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to record from your Cable Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV sys- tem installer’s attention to Article 820-40 of the NEC that provides guidelines for proper ground- ing and in particular, specifies that the cable ground shall be connected to the grounding sys- tem of the building as close to the point of cable entry as practical.

CONNECTING TO EXTERNAL

INPUT JACKS

When you watch a program recorded on another source (VCR or video camera), use the audio/video input jacks on the front of the TV/VCR/DVD. Connect the audio/video output jacks of another source to the AUDIO L/R and VIDEO jacks of this TV/VCR/DVD.

Then press the CHANNEL button K or L until “AUX” appears on the screen.

NOTE:

•When you connect a monaural VCR (another source) to this TV/VCR/DVD, connect the Audio output jack of the monaural VCR (another source) to the AUDIO L jack of this TV/VCR/DVD. The audio will output in both L and R channel equally.

INSTALLING THE BATTERIES

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 “AA” penlight batteries into the battery compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the cover.

EXTERNAL INPUT MODE

When using an external input signal (another VCR or video camera), connect the player’s audio/video out- put cables to the AUDIO L/R IN/

VIDEO IN jacks of yourAUX TV/VCR/DVD. Then press the

CHANNEL button K or L until “AUX” appears on the screen.

[Another source]

etc.

To the video output jack

To the audio output jacks

HEADPHONE VIDEO L-AUDIO-R

Audio/Video cable

(not supplied)

[Front of the TV/VCR/DVD]

[Fig. 5]

- 12 - EN

1C29