Magnavox CCZ252AT Timer Recording cont’d, Time OFF To Correct Press Clear To END Press Exit

CCZ252comb.QX33 4/6/99 8:50 PM Page 33

Timer Recording (cont’d) 33

4

Use the Number buttons (1 - 8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not yet been stored).

NOTE: If you select a number that has already been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on-screen for a few seconds. Then information about the program in that position will appear on-screen. If this happens, press the STATUS/EXIT button. Then use the Number buttons to select another position.

5

●If you are using an antenna or cable connection, enter the chan- nel of the TV program you want to record (you must enter a 0 before all single-digit channels).

●If you are recording from line input, press 0, 0. A/V IN will appear on-screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

4-7

POWER			SLEEP
	2	3	ALT.CH
1
4	5	6	o
			CHANNEL
7	8	9	p
	0	+100	o
SPEED		MUTE	VOLUME
			p
	o
	PLAY
REW			F.FWD
	STOP
	p
REC/OTR	MEMORY	PAUSE/STILL
			o
MENU	STATUS/EXIT	CLEAR	TRACKING

p

Helpful Hints

•If the numbers entered do not match the TV/VCR’s calendar, the entry will be rejected and a question mark will appear on screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the cursor is flashing on the item you want to change. Then enter the cor- rect information.

Instructions continue on page 34.