Magnavox CCZ252AT Hooking Up the TV/VCR, Hook up your TV/VCR using one of the connections shown

Page 6

CCZ252comb.QX33 4/6/99 8:50 PM Page 6

6 Hooking Up the TV/VCR

1

Hook up your TV/VCR using one of the connections shown.

A.

Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an anten- na to the ANT(enna) Jack.

ANT.

ANT.

B.

Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

Connect the Cable signal to the IN

Jack on the Cable Box.

Connect an RF coaxial cable (75- ohm, not supplied) to the OUT

Jack on the Cable Box and to the OUTIN ANT(enna) Jack on the TV/VCR.

ANT.

ANT.

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (not supplied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Rod Antenna

(not supplied)

ANT.

ANT.

Image 6

Contents CCZ252AT Dear Philips Magnavox product owner For Customer Use Features Safety Precautions Introduction Table of Contents Using the Remote Control Before Using the TV/VCRPutting Batteries in the Remote Control TV/VCR MaintenanceHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Hooking Up the TV/VCR cont’d Crooked Pin Straight PinTurning On the TV/VCR Select another channelPress the Number 1 button to choose Select LAN Language SelectionPress the Menu button GuageAutomatic Channel Setup Input Cable Exit PRIM. Setup VCR Program VCR Setup CaptionAdding/Deleting Channels Press the Number 3 button to select ADD/DELETE ChannelSetting the Clock Manual Clock SettingPress the Number 6 button to select SET Clock Setting the Clock cont’d Press the Number 2 button to select SET Manual ClockAutomatic PBS Channel Selection Press the Number 1 button to select SET PBS CH AutoManual PBS Channel Selection UAL Find the timeDaylight-Saving Time Time Zone Press the Number 4 button to select SET Time ZonePress the STATUS/EXIT button twice Front Panel Rear Panel ANTenna Jack Antenna HoleRemote Control Buttons Channel / Buttons Volume / ButtonsALT. CH Alternate Channel Button Mute ButtonAdjusting the Picture Controls More brilliant Adjusting the Picture Controls cont’dDecrease Increase SofterOFF Mode On ModeCounter only Mode On-Screen Status DisplaysPress the PLAY/ button or the STOP/ button to select REMINDER.1Playing Press the RECord/OTR button once to start recording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording OTRRerecording Tape Duplication Different brands of equipment may operate differentlyTimer Recording Select a once, daily or weekly recordingTimer Recording cont’d Time OFF To Correct Press Clear To END Press ExitPlease see page 48 for more Helpful Hints Checking or Clearing Timer Recordings Record Defeat Press the Number 4 button so that on appears besideRecord Defeat Setting the Sleep Timer Closed Caption CaptionCAPTION1 Closed Caption cont’d Standard Closed CaptionsVolume Bar Repeat Play Press the Number 2 button so that on appears besideRepeat Play B Repeat Play Insert a tape in the TV/VCR Press the Menu buttonRepeat Play cont’d Button to reset the real-time counter to zero Real-Time Counter MemoryWhile the counter remains on-screen, press the Clear Automatic Operation Features Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still PictureSpecifications GlossaryHelpful Hints Helpful Hints cont’d Limited Warranty TV/VCR CombinationIndex Supplied Accessories