Magnavox CCZ130AT owner manual Specifications, Glossary

Page 47

CCZ130comb 4/5/99 7:32 PM Page 47

Specifications

General

CRT: 13-inch in line gun

Television system: NTSC-M

Closed caption system: Section 15.119, FCC (Federal Communications Commission) Standard

Video Heads: Two heads

Tape width: 1/2 inch (12.65 mm) Tape speed

SP: 33.35 mm/sec.

LP: 16.67 mm/sec.

SLP: 11.12 mm/sec.

Operating Temperature: 41˚F (5˚C) to 104˚F (40˚C)

Relative Humidity: 10% to 75%

Power requirement: AC 120V, 60Hz

Power consumption: 75W

Sound output: 1W Dimensions:

15-13/16" (H) x 15-3/16" (W) x 14-3/4" (D) 402 mm x 386 mm x 375 mm

Weight: 27.5 lbs (12.5 kg)

Tuner Broadcast Channels

VHF 2-13, UHF 14-69

Cable TV Channels

Midband: A – 1

Superband: J – W

Hyperband: A-5 – A-1

Special Channel: 5A

Ultraband: 37 – 94, 100 – 125

Terminals

Antenna IN: VHF/UHF 75 ohms unbalanced

Video IN: RCA connector

Audio IN: RCA connector

Earphone: 3.5 mm CES

Electrical Specifications

Video input level: 0.5~2.0Vp-p

Audio input level: -10dBv

Video S/N ratio

SP: More than 42dBµ

Audio S/N ratio

SP: More than 38dB

Designs and specifications are subject to change without notice and without our legal obligation.

Specifications / Glossary 47

Glossary

AUDIO Jack: jack located on the front of the TV/VCR which is used to record audio from anoth- er source.

Automatic Channel Setup: process in which the TV/VCR scans all available channels and places the ones you receive in its memory. Then, when you push the CHANNEL o/p buttons, you only scan through channels you receive.

Bands: settings that allow you to tune channels.

•Antenna – VHF (very high frequency; channels 2

-13) and UHF (ultra high frequency; channels 14

-69).

•Cable – all standard channels can be received without a Cable Box.

Brightness: adjusting increases or decreases the brightness of the color on-screen.

Color: adjusting pales or brightens the TV/VCR color.

Dubbing: copying a tape using a VCR.

HQ: high quality; a feature in the TV/VCR circuitry which provides enhanced picture detail.

Line Input: The channel to which you set your TV/VCR during dubbing. The line input channel is always channel 00 (A/V IN).

Mode: a TV/VCR operation.

OTR: One-Touch Recording; programming a timed recording that starts immediately and records for 30 minutes to eight hours, whichever you specify.

Picture: adjust to increase or decrease the con- trast of the picture on-screen.

Sharpness: adjusting softens or clarifies the picture on-screen.

Tape Speeds: how fast the tape travels during playback or recording.

•SP (standard play) – fastest tape speed (record- ing time for a T120 tape is approximately two hours); best picture quality.

•LP (long play) – average tape speed (recording time for a T120 tape is approximately four hours).

•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).

Tint: adjusting changes the tints of the picture on the TV/VCR from purple to green.

VCR: video cassette recorder.

VIDEO Jack: jack located on the front of the TV/VCR which is used to record video from anoth- er source.

Page 46 Page 48
Image 47
Page 46 Page 48
Contents CCZ130AT For Customer Use Dear Philips Magnavox product ownerIntroduction FeaturesSafety Precautions Table of Contents Before Using the TV/VCR Rod Antenna Hook up your TV/VCR using one of the connections shownHooking Up The TV/VCR Crooked Pin Straight Pin Hooking Up The TV/VCR cont’dTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Menu button Language SelectionWait for the TV/VCR to set up channels Automatic Channel SetupCHANNEL, then press the FF/SEARCH B button Adding/Deleting ChannelsPress the PLAY/ button or the STOP/ button to select Manual Clock Setting Setting the ClockSetting the Clock cont’d Automatic PBS Channel Selection Wait for the TV/VCR to find the time Manual PBS Channel Selection NOW Searching flashes on the TV/VCR screen Press the Menu button Daylight-Saving TimeTime Zone Front Panel ANTenna Jack AC Power CordRear Panel Remote Control Buttons Channel o/p Buttons STATUS/EXIT ButtonMenu Button Memory ButtonAdjusting the Picture Controls Softer Adjusting the Picture Controls cont’dDecrease Increase More brilliantIf you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onReminder ReminderPlaying Recording options are on pages 30 RecordingPress the RECord/OTR button repeatedly until One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationDaily Timer RecordingInstructions continue on Timer Recording cont’dPlease see page 48 for more Helpful Hints Checking or Clearing Timer Recordings REC Defeated Defeat RecordingSetting the Sleep Timer Screen Closed CaptionExample MenuStandard Closed Captions Closed Caption cont’dVolume Bar Repeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the Memory button to set the start position a Press the STATUS/EXIT button to remove the display. aReal-Time Counter Memory Automatic Operation Features Viewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPGlossary SpecificationsHelpful Hints Helpful Hints cont’d TV/VCR Combination Limited WarrantyControls IndexSupplied Accessories
Top Page Image Contents