Magnavox CCZ130AT Hooking Up The TV/VCR, Hook up your TV/VCR using one of the connections shown

Page 6

CCZ130comb 4/5/99 7:31 PM Page 6

6 Hooking Up The TV/VCR

1

Hook up your TV/VCR using one of the connections shown.

A.

Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an antenna to the ANT(enna) Jack.

ANT.

B.

Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

Connect the Cable signal to the IN Jack on the Cable Box.

Connect an RF coaxial cable (75- ohm, not supplied) to the OUT Jack

on the Cable Box and to the	OUT	IN
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.

ANT.

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (not sup- plied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Rod Antenna

(not supplied)

ANT.

Image 6

Contents CCZ130AT Dear Philips Magnavox product owner For Customer UseFeatures Safety PrecautionsIntroduction Table of Contents Before Using the TV/VCR Hook up your TV/VCR using one of the connections shown Hooking Up The TV/VCRRod Antenna Hooking Up The TV/VCR cont’d Crooked Pin Straight PinYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRLanguage Selection Press the Menu buttonAutomatic Channel Setup Wait for the TV/VCR to set up channelsAdding/Deleting Channels Press the PLAY/ button or the STOP/ button to selectCHANNEL, then press the FF/SEARCH B button Setting the Clock Manual Clock SettingSetting the Clock cont’d Automatic PBS Channel Selection Wait for the TV/VCR to find the time Manual PBS Channel Selection NOW Searching flashes on the TV/VCR screen Daylight-Saving Time Press the Menu buttonTime Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons Memory Button STATUS/EXIT ButtonMenu Button Channel o/p ButtonsAdjusting the Picture Controls More brilliant Adjusting the Picture Controls cont’dDecrease Increase SofterIf you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFFReminder ReminderPlaying Recording Recording options are on pages 30One-Touch Recording Press the RECord/OTR button repeatedly untilRerecording Tape Duplication Different brands of equipment may operate differentlyTimer Recording DailyTimer Recording cont’d Instructions continue onPlease see page 48 for more Helpful Hints Checking or Clearing Timer Recordings Defeat Recording REC DefeatedSetting the Sleep Timer Menu Closed CaptionExample ScreenClosed Caption cont’d Standard Closed CaptionsVolume Bar Repeat Play B Repeat Play Insert a tape in the TV/VCR Press the Menu buttonPress the STATUS/EXIT button to remove the display. a Press the Memory button to set the start position aReal-Time Counter Memory Automatic Operation Features Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still PictureSpecifications GlossaryHelpful Hints Helpful Hints cont’d Limited Warranty TV/VCR CombinationIndex ControlsSupplied Accessories