CCZ196comb.QX33 4/6/99 7:04 PM Page 8
8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure there are batteries in the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the screen shown below will appear.
SELECT LANGUAGE
> ENGLISH | ON |
1
2
3
POWER
SLEEPSPEED
REC/OTR
PLAY
REW
STOP
MENU | STATUS/EXIT |
|
|
EJECT |
|
MEMORY |
|
PAUSE/STILL | 4 |
F.FWD | |
CLEAR |
|
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
2
Press the PLAY/K button or the STOP/L button to select
English or Spanish
3
Press the MENU button. The screen shown below will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
4
Press the F.FWD/B button to begin automatic channel setup. The TV/VCR will memorize all available channels. When channels are set, CHANNELS ARE SET will appear
(If you try to set up channels when there is no antenna or cable connected to the TV/VCR, programming will appear to take place, but eventually a NO TV SIGNALS ... message will appear on- screen. Connect an antenna or cable to the TV/VCR, then try again. You may need to follow the steps on page 10 instead.)
5
Use the CH(annel). Up/Down buttons or the Number buttons on the remote control to select a TV/VCR chan- nel. Use the VOL(ume). Up/Down buttons to adjust the sound.
1 | 2 | 3 |
|
|
4 | 5 | 6 | CH. | 5 |
| ||||
7 | 8 | 9 |
| |
A.CH | 0 | +100 | VOL. | |
CABLE/DBS | COMBI |
|
| |
|
| VCR PLUS+ |
|
|
VAR.SLOW | /ENTER | MUTE |
| |
TRACKING | F.ADV | SLOW |
| |
SMART | SMART | SKIP INDEX |
|
|
PICTURE | SOUND | SEARCH SEARCH |
|
|
Helpful Hints
•If you do not see any
•To skip step 2, press the STATUS/EXIT button. All
•You cannot set up channels if you are using a Cable Box.
•Line Input mode will always be stored in the TV/VCR’s memory as channel 00. When you select chan- nel 00, A/V IN will appear on- screen briefly. Press the CH(annel). Up/Down buttons or Number but- tons to select another channel.