Magnavox CCZ196AT owner manual Before Using the TV/VCR, Putting Batteries in the Remote Control

Page 5

CCZ196comb.QX33 4/6/99 7:04 PM Page 5

Before Using the TV/VCR 5

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by pressing in the tab and lifting the lid.

2

Place three AA batteries inside the battery compartment with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not accidentally erased.

1

To prevent accidental erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

Using the Remote Control

●Press the COMBI button, then point the remote control at the TV/VCR’s remote sensor when using the remote control to operate the TV/VCR. Press the CABLE/DBS button, then point the remote control at the Cable Box/DBS when using the remote control to operate the Cable Box/DBS.

●Do not put objects between the remote control and the TV/VCR.

1

2

3

1

2

VCR Maintenance

●In this TV/VCR, use only tapes with the mark.

●Make sure any light adhesive stick-on notes are removed from the video cassette tape before putting the tape in the TV/VCR. Removable labels like these can jam the TV/VCR.

●Periodic maintenance is required to maintain your TV/VCR’s excellent performance. This TV/VCR has an automatic head cleaning system. However, the video heads will eventually require cleaning or replacement. Cleaning or replacement of the video heads should be performed by an authorized service cen- ter.

Helpful Hints

•The remote control and its batteries are supplied.

•Do not mix alkaline and man- ganese batteries.

•Do not mix old and new batteries.

Image 5

Contents CCZ196AT For Customer Use Dear Philips Magnavox product ownerIntroduction FeaturesSafety Precautions Table of Contents Putting Batteries in the Remote Control Before Using the TV/VCRUsing the Remote Control VCR MaintenanceHooking Up The TV/VCR Hook up your TV/VCR using one of the connections shownOn the Cable Box and to theOUTIN ANTenna Jack on the TV/VCR Rod AntennaUse a Video cable to connect the Video Hooking Up The TV/VCR cont’dOUT Jack on the VCR to the Video Jack on the rear of the TV/VCRPress the Menu button. The screen shown below will appear You cannot set up channels if you are using a Cable BoxTurning On the TV/VCR Press the STATUS/EXIT button Language SelectionPress the Combi button, then press the Menu button Wait for the TV/VCR to set up channels Automatic Channel SetupPress the PLAY/ button or the STOP/ button to select Adding/Deleting ChannelsProgramming of the channel you added or deleted will appear Press the STATUS/EXIT button once or twiceManual Clock Setting Setting the ClockMonth To Correct Press Clear To END Press Exit Setting the Clock cont’dAutomatic PBS Channel Selection Manual PBS Channel Selection Wait for the TV/VCR to find the timeManual PBS Channel Selection NOW Searching flashes on the TV/VCR screen Daylight-Saving Time Time Zone Within 30 seconds, press the CABLE/DBS button Setting the Remote to Operate a Cable Box/DBSPress the Mute button Setting the Remote to Operate a Cable Box/DBS cont’d Front Panel Rear Panel Remote Control Buttons PAUSE/STILL Button VOLume. Up/Down ButtonsMemory Button REWind/ ButtonMore brilliant Adjusting the Picture ControlsMore purple SofterSmart Picture If another remote control beeps If another remote control beepsRemote Locator Press the Mute button, then press the PAUSE/STILL buttonIf you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFFIf you select Status OFF ChannelReminder ReminderInsert a tape in the TV/VCR PlayingGiven below RecordingRecording options are on pages 33 Distortion may appear on the tapePress the STOP/EJECT but Ton on the TV/VCR to stop the OTR One-Touch RecordingAudio and video cables are not included Different brands of equipment may operate differentlyDaily Timer RecordingRect information Timer Recording cont’dFriday TimeChecking or Clearing Timer Recordings Station Setting Up the VCR Plus+ Programming SystemTV Channels Setting Up the VCR Plus+ Programming System cont’d You have completed the steps on pages Timer Recording With the VCR Plus+ Programming SystemTimer Recording With the VCR Plus+ Programming System cont’d Follow the steps below to prevent accidental recording Defeat RecordingIf the power fails, you might lose Sleep timer setting Setting the Sleep TimerExample Closed CaptionMenu ScreenHalf-screen text Closed Caption cont’dStandard Closed Captions To turn Smart Sound On or Off To set the Volume BAR to on or OFFSmart Sound Mode Repeat PlayRepeat Play Instructions continue on00000 B Repeat Play cont’dAppear on-screen Press the STATUS/EXIT button. The real-time counter willTape in the TV/VCR Index SearchAutomatic Operation Features Forward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureSpecifically… MTS Broadcast Stereo SystemUnderstanding On-Screen Displays MTS Broadcast Stereo System cont’d Glossary SpecificationsHelpful Hints Helpful Hints cont’d Model # Serial # Limited WarrantyPlease contact Philips at French Speaking English Speaking Above One-touch recording Adding Table of contents Deleting Rewind, power offSetup PowerCCZ196comb.QX33 4/6/99 705 PM CCZ196comb.QX33 4/6/99 705 PM Supplied Accessories