Magnavox CCA252AT99 owner manual Timer Recording cont’d

Page 33

Timer Recording (cont’d) 33

4

Use the Number buttons (1-8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not been stored yet).

NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen for a few seconds. Then information about the program in that position will appear on the screen. If this happens, press the STATUS/EXIT but- ton. Then use the Number buttons to select another position.

5

Use the Number buttons to enter the channel of the TV program you want to record.

●If you are recording from line input, press 0, 0. A/V IN will appear on the screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 34.

4-7

POWERSLEEP

	PLAY
REW		F.FWD
	STOP
MENU	STATUS/EXIT	CLEAR

1	2	3
4	5	6	CH.
4	5	6
7	8	9
	0	ALT. CH	VOL.
	0	ALT. CH
SPEED	MEMORY	PAUSE/STILL
REC/OTR	TRACKING		MUTE

Helpful Hints

•If the numbers entered do not match the TV/VCR’s calendar, the entry will be rejected and a question mark will appear on the screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the cursor is flashing on the item you want to change. Then enter the cor-

rect information.

Image 33

Contents CCA252AT For Customer Use Dear Philips Magnavox product ownerSafety Precautions FeaturesIntroduction Philips Consumer Electronics Company recommends thatTable of Contents Using the Remote Control Putting Batteries in the Remote ControlTV/VCR Maintenance Erasure PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Crooked Pin Straight Pin Hooking Up the TV/VCR cont’dTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Menu button Language SelectionAutomatic Channel Setup Press the PLAY/ o button or the STOP/ p button to select Adding/Deleting ChannelsSetting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dSET Auto Clock Please Wait Several Minutes Manual PBS Channel Selection Press the PLAY/ button or the STOP/ button to Select SET PBS CH. MANUAL. Then, press the F.FWD/BUse the Number buttons to select your PBS station Daylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons REWind/ Button STOP/ ButtonSTATUS/EXIT Button Menu ButtonAdjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dMore brilliant SofterIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFReminder Press the PLAY/ button or the STOP/ button to selectPlaying To stop recording, press the STOP/ button Tape Speeds RecordingOTR One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationDaily Timer RecordingTimer Recording cont’d Timer Recording cont’d With the TV/VCR on, press the Menu button Checking or Clearing Timer RecordingsVCR PROGRAM, then press the F.FWD/B button Program REVIEW, then press the F.FWD/B buttonDefeat Recording Repeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the STATUS/EXIT button to remove the menu. A-B Repeat Play cont’dPress the STATUS/EXIT button. The real-time counter will Real-Time Counter MemoryForward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureSmartLock Example Specific Ratings SmartLock cont’dTo change the access code, follow these steps Rating Explanations Ground Blue BackgroundSleep Timer Example Closed CaptionMenu ScreenHalf-screen text Closed Caption cont’dVolume Bar Automatic Operation Features Specifications Glossary Helpful Hints Helpful Hints cont’d TV/VCR Combination Limited WarrantyIndex Deleting Reviewing SetupPage Page Supplied Accessories