Clock Set
See | page 19. |
| |
OSD On/Off |
On | | Activates the operational status display (e.g., ) on the TV screen. |
Off | | Deactivates the operational status display (e.g., ) on the TV screen. |
Remote Controller Sound
Turns on the beep sound.
Turns off the beep sound.
Screen Saver
Auto Power Off | Turns the player off if stop mode or picture pausing continues for about 20 minutes. |
On | Activates the screen saver if stop mode or picture pausing continues for about 20 minutes. |
Off | Deactivates the screen saver. |
Notes
•Toshiba does not guarantee that this function will protect your display.
•To close the screen saver, press any button on the player or the remote control.
•When an HD DVD disc is used, this function activates only in stop mode.
Maintenance
Initialize | To reset all the settings listed on | page 30, 31 to factory set default. |
| Press / buttons to select “Yes” then press OK button. |
Update (Firmware | If you have a broadband internet service, you may obtain firmware update over the internet using the LAN |
update) | port on the back of your player. | |
| • | BEFORE BEGINNING THE FIRMWARE UPDATE PROCESS, BE SURE TO REMOVE ANY DISCS FROM |
| | YOUR PLAYER. | |
| | Please configure the LAN port ( | page 17). You may need to turn on DHCP and DNS ( page 22). |
| • | Press SETUP and select “General” > “Maintenance”. Follow the instructions on the screen. |
| • | If a firmware update is available for your player, it will be downloaded. Once the firmware update dowload |
| | process has finished, the player’s power will automatically switch off. You must wait until this process has |
| | finished. | |
| • | DO NOT UNPLUG, TURN OFF, OR USE ANY OTHER FEATURE OF YOUR PLAYER DURING THE |
| | FIRMWARE UPDATE PROCESS. Doing so will cause the writing of the firmware update to the player to be |
| | halted and the player may no longer operate properly. If the player stops working, please contact Toshiba |
| | Customer Solutions at (800) 319-6684. |
| • | If no fimware update is available, the player will quickly exit the firmware update process. |
Persistent Storage | To open the menu to control player’s memory allocated for content. |
| The menu selections will vary depending on the content. Operate following the instructions displayed on your |
| screen. | |
Twin Format Disc
To select a layer to play, HD DVD or DVD of an HD DVD Twin Format Disc. (Not available if a disc is loaded.)
HD DVD | Only the HD DVD layer is played. |
DVD | Only the DVD layer is played. |
Note
• For combination discs, select the desired version by disc side (see label for information).
35
HD-A3KU HD-A3KC
Result in hazardous radiation exposure
Procedure
This HD DVD player employs a Laser System
Location of the required label
Important Safety Instructions
Precautions
Wait
Do not use the unit when moisture condensation may occur
Moisture condensation occurs during the following cases
Table of contents
Disc Specification
Features
Disc compatibility
Customer support
Important notes about HD DVD
HD output jacks
Certain system requirements
Rear panel
Index to parts and controls
Front panel
Display
Remote control
Loading batteries
Accessories
Remote control
Supplied accessories
Proceed the following steps to set the player ready
Resolution and connections
Why Hdmi connection is most recommended?
Preparation
Via Video yellow input
Connecting to a TV
Via Hdmi input
Via component video input
Via analog audio output
Connecting to audio system
Via Hdmi output
Via optical digital audio output
With integrated router
Power connection
LAN connection
Connect either
Language
Powering on
Setting up the player
If the time is correct, select OK by
Time
Press / to select Clock Set, then press
Confirm the time is correct
Below, then press OK
Resolution
Press To select Resolution Setting, then press OK
Press To select Picture, then press OK
Press / to select Audio, then press OK
Audio output
To select each of the followings, then press OK
Ethernet
Press To select Ethernet, then press OK
Select Other and press OK button
Cookie Setting
Network Speed
Select the speed and press OK button
Playback starts If playback does not start, press Play
Playing
Playing a disc
To change playback speed
To pause playback
To stop playback
To resume playback from the location last stopped
During playback, press Subtitle
To select subtitles
To select the sound
To select the camera angle
To check the current status
To locate a position
To play repeatedly
Cursor controls
Requirements for HD DVD discs/Web-enabled network content
HD DVD playing options in the future
C/D buttons
Output sound conversion table
Group Setting Disc Details
Customizing the function settings
During stop, press Setup
Setup Menu appears
Picture
Settings
Language
Audio
On Screen Language
How to select a language
Subtitle Language
Audio Language
General
Ethernet
Update
Remote Controller Sound Off
Maintenance Initialize
Update Firmware
Symptom Remedy
Before calling service personnel
Preamble
Pre-installed software
H i b i t a GNU General Public License Version 2, June
No Warranty
H i b i t B
END of Terms and Conditions
Page
No Warranty
H i b i t D
H i b i t C
Specification
Your Responsibility
Limited One 1 Year Warranty on Parts
Rental Units
Commercial Units
How to Obtain Warranty Services
Your Responsibility
Limited Canadian Warranty For Toshiba Brand HD DVD Players
Limited Warranty for Commercial Units
Rental Units
General Provisions
Arbitration and Dispute Resolution
How to Obtain Warranty Services
Information on Customer Support