14.5 Maintenance Checklist
WARNING
Explosion Hazard
Service and annual inspection must be done by a contractor qualified in the installation and service of
Turn off gas and electrical supplies before performing service or maintenance.
Failure to follow these instructions can result in death, injury or property damage.
Installation Code and Annual Inspections:
All installations and service of ROBERTS GORDON® products must be performed by a contractor qualified in the installation and service of products sold and supplied by
The Vicinity of the Heater Do not store or use flammable objects, liquids or vapors near the heating sys- tem. Immediately remove these items if they are present.
See Page 3, Section 3.
Vehicles and Other Objects
Maintain the clearances to combustibles.
Do not hang anything from, or place anything on, the heater.
Make sure nothing is lodged underneath the reflector, in between the tubes or in the decorative or protective grilles (included with select models).
Immediately remove objects in violation of the clearances to combustibles.
See Page 3, Section 3.
Reflector | Make sure there is no dirt, sagging, cracking or distortion. |
| Do not operate if there is sagging, cracking or distortion. |
| Make sure reflectors are correctly overlapped. See Page 19, Figure 7.4.3. |
| Clean outside surface with a damp cloth. |
|
|
Vent Pipe | Venting must be intact. Using a flashlight, look for obstructions, cracks on the |
| pipe or gaps in the sealed areas or corrosion. |
| The area must be free of dirt and dust. |
| Remove any carbon deposits or scale using a wire brush. |
|
|
Outside Air Inlet | Inlet must be intact. Look for obstructions, cracks on the pipe or gaps in the |
| sealed areas or corrosion. |
| The area must be free of dirt and dust. Clean and reinstall as required. |
|
|
52