Universal Remote Control Unifier URC-100 owner manual E U n i f i e r Erasing All Settings

Page 24

T h e U n i f i e r

Erasing All Settings

Should you wish to make a clean start, you can reset the Unifier to its factory default settings by pressing and holding both the POWER OFF button and the STOP button for ten seconds. Continue to hold both buttons as the display flashes ERASE nine times, then CLEAR.

POWER

OFF

Button

STOP

Button

The Unifier displays a self testing routine for a few seconds, then returns to normal operating mode.

Recalling Pre-Programmed Settings

If you wish to recall a previously programmed code number so that you can write it down, follow these steps:

1Press and hold both the DEVICE button you want to identify and the MUTE button. Keep holding them down until the display says SET.

2Press the INFO button.The Device Name will appear (blink twice) followed by the three digit number.

22

Image 24

Contents Page Thank You Table of Contents Battery Installation Getting StartedE U n i f i e r CongratulationsButton Layout C 1 0Shift Button Light ButtonBasic Setup Pre-Programmed MethodLeft Right Light E U n i f i e r Learning Method Ready E U n i f i e r C 1 0 Volume Control Punch Through SET Advanced Setup Own Two VCR’s? Set Aux to be VCR2Left Right Audio C 1 0 Editing Device NamesUP Cursor Button deletes ALL text C 1 0 Macro Button Setup M1 ##Pause Erasing One Learned Command C 1 0 Overview of ErasingE U n i f i e r Erasing All Learned Commands in One Device C 1 0 Erasing All Learned Commands in ALL Devices Erasing a MacroE U n i f i e r Erasing All Settings Recalling Pre-Programmed SettingsOptional Expander E U n i f i e r Pre-Programmed Code Tables Audio Amps, Preamps and A/V Receivers Brand Code NumbersKoss Audio Command Locations Command Button LocationCD CD Players and Changers SurrLotte CD Command Locations DVD DVD Players and Changers DVD Laser Disc PlayersDVD Command Locations AUX Tape Decks AUX Command Locations AUX Lighting & Custom ProductsAUX Command Locations SAT Satellite ReceiversSAT DVR TiVo, Replay etc SAT Command Locations TV TVs, Plasmas, Projectors and MonitorsCandle Nikei TV Command Locations Auto CHVCR VCRs and TV/VCR Combos VCR Command Locations VCR Command Locations CBL Cable TV Tuner/DescramblerCombano Cable Command Locations Frequently Asked Questions Why does the display flash at me sometimes?What is a Macro? Can I program the Unifier on a computer?If the batteries run out, will I lose my settings? Who can I call for more answers?Warranty SpecificationsE U n i f i e r