Universal Remote Control Unifier URC-100 owner manual Basic Setup, Pre-Programmed Method

Page 7

U R C - 1 0 0

Basic Setup

You can start setting up your Unifier using either the Pre-Programmed Method or the Learning Method. However, all the buttons of the Unifier are setup at once with the Pre-Programmed Method, so it is usually faster than the one-button-at-a-time Learning Method.

Pre-Programmed Method

1Power on the A/V component you wish to setup, so that you can test codes by sending power off commands.

2Refer to the pre-programmed code tables on pages 25 - 46 and write down the code numbers listed for your A/V component. The code numbers are listed by categories of devices, then by brand. See page 25 for a category list.

3Press and hold both the SHIFT and ENT (Enter) buttons for approximately three seconds. The top of the display will blink “SET” then one of the eight device names. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If you don’t press a button within that time, the Unifier will time out and return to normal operation.

SHIFT	ENT
Button	Button

5

Image 7

Contents Page Thank You Table of Contents Congratulations Battery InstallationGetting Started E U n i f i e rC 1 0 Button LayoutLight Button Shift ButtonPre-Programmed Method Basic SetupLeft Right Light E U n i f i e r Learning Method Ready E U n i f i e r C 1 0 Volume Control Punch Through SET Own Two VCR’s? Set Aux to be VCR2 Advanced SetupLeft Right C 1 0 Editing Device Names AudioUP Cursor Button deletes ALL text M1 ## C 1 0 Macro Button SetupPause C 1 0 Overview of Erasing Erasing One Learned CommandE U n i f i e r Erasing All Learned Commands in One Device Erasing a Macro C 1 0 Erasing All Learned Commands in ALL DevicesRecalling Pre-Programmed Settings E U n i f i e r Erasing All SettingsOptional Expander E U n i f i e r Pre-Programmed Code Tables Brand Code Numbers Audio Amps, Preamps and A/V ReceiversKoss Command Button Location Audio Command LocationsSurr CD CD Players and ChangersLotte CD Command Locations DVD Laser Disc Players DVD DVD Players and ChangersDVD Command Locations AUX Tape Decks AUX Lighting & Custom Products AUX Command LocationsSAT Satellite Receivers AUX Command LocationsSAT DVR TiVo, Replay etc TV TVs, Plasmas, Projectors and Monitors SAT Command LocationsCandle Nikei Auto CH TV Command LocationsVCR VCRs and TV/VCR Combos VCR Command Locations CBL Cable TV Tuner/Descrambler VCR Command LocationsCombano Cable Command Locations Can I program the Unifier on a computer? Frequently Asked QuestionsWhy does the display flash at me sometimes? What is a Macro?Who can I call for more answers? If the batteries run out, will I lose my settings?Specifications WarrantyE U n i f i e r