T h e U n i f i e r
4Choose the name of the device you’d like to setup. Use the cursor LEFT or RIGHT buttons to change the flashing name.
For Example: I wanted to setup the TV Device button first, so I pressed the cursor LEFT or RIGHT until “TV” was flashing on the display.
LEFT | RIGHT |
5Point the Unifier at the component, then enter the first three digit code number from your notes using the numbered buttons. After you enter each three digit code number, look at the component to see if it turned off.
Using the numbered buttons, enter the 3 digit code number.
Continue to enter code numbers until the component powers off.
For Example: I have a Sony TV. I found the code numbers 070, 139,147, 126, 185, 194 and 085 under Sony in the TV TABLE. Using the numbered buttons on the Unifier, I entered 070 and looked at the TV. It didn’t turn off, so I entered 139, then 147 and so on, until I found the code that powered off the TV.
6