Toshiba MV13P3 owner manual Safety Check, Heat, NEC Section

Page 5

20.SAFETY CHECK

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition.

21.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

22.NOTE TO CABLE TV SYSTEM INSTALLER

This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

EXAMPLE OF ANTENNA GROUNDING AS PER THE

NATIONAL ELECTRICAL CODE

		ANTENNA LEAD IN WIRE
	GROUND CLAMP
		ANTENNA DISCHARGE UNIT
		(NEC SECTION 810-20)
	ELECTRIC SERVICE	GROUNDING CONDUCTORS
	EQUIPMENT	GROUNDING CONDUCTORS
	EQUIPMENT	(NEC SECTION 810-21)
		(NEC SECTION 810-21)
		GROUND CLAMPS
	NEC-NATIONAL ELECTRICAL CODE	POWER SERVICE GROUNDING
	S2898A	ELECTRODE SYSTEM
	S2898A	(NEC ART 250, PART H)

IMPORTANT RECYCLING INFORMATION

This product uses both Cathode Ray Tube (CRT) and other components that contain lead. In your community there might be regulations that require you to dispose these materials properly under environmental considerations. Please contact your local authorities, or the Electronic Industries Alliance (http://www.eiae.org) for disposal or recycling information.

3

5L80301C P01-09

3

20/4/04, 16:25

Image 5

Contents MV13P3 TV/CABLE Mode SelectionRisk of Electric Shock Do not Open Accessories CleaningPower Source Grounding or Polarization Read InstructionsPower Lines POWER-CORD ProtectionReplacement Parts LightningNEC Section Safety CheckHeat Features Table of Contents When YOU Experience the Above Conditions Safety PrecautionsMoisture Condensation Moisture will Condense on the Unit in the Following CasesWider Hole and Blade AC Outlet Power SourceTo USE AC Power Front Rear Location of ControlsDescription of Controls FrontSpeed button Sets the tape speed for recording Remote ControlCursor Selects an item in the menu Battery Precautions Battery InstallationEffective Distance of the Remote Control FeetJack Antenna ConnectionsOhm matching transformer Antenna Jack Combiner UHF 300 ohm VHF 300 ohmCable TV Connections For Subscribers to Basic Cable TV ServiceFor Subscribers to Scrambled Cable TV Service Enter Starting SetupSetting the Language Auto Clock Setting Auto Clock SettingAuto Clock Adjustment To SET Auto Clock to OFFPress MENU. Press Bor a to select option Auto for automatic setting read EDS in the signalPress or to select Daylight Saving TIME, then press a Menu screen is clearedPress Bor Ato set Manual Clock SettingMonth, then press As in , then pressAdjust the volume level by Press PowerTV Operation Cable TV ChannelsMute CallChannel + MuteSleep Closed Caption Channel ReturnSleep Closed CaptionTo View Closed Captions What is Closed CAPTIONING?Closed Captioning with a VCR TV/CABLE Selection Cable TV chartTo Memorize Channels Numbers will remain red until auto memorizing is complete Automatic Memory TuningThen press a Channel selection To ADD/DELETE ChannelsTo Register Password Setting the V-CHIPEnter the same password Using Direct channelTo SET the V-CHIP To use the TV after the TV is protected EnterTo Change Password Press B or Ato select ON/OFF TIMER, then To SET the on TimerOn TIMER, then press a Option Press aOption Press a To SET the OFF TimerPress Bor Ato select Selection Pressing Picture Control AdjustmentsCancel Mode Picture Quality Adjusting the Picture PreferencePress B or a to select option PREFERENCE, then press a Press or to select the desired pictureLoading and Unloading a Video Cassette Automatic Power on and PlayLoading UnloadingSP Standard Play To Prevent Accidental Erasure To Record AgainTape Speed and Maximum PLAYBACK/RECORDING Time To Start Playback PlaybackStop To Stop PlaybackREW Digital Tracking ControlsTo Rewind or Forward the Tape Rapidly FORWARD/REVERSE Picture SearchStop Special PlaybackSkip Search PAUSE/STILLPress Bor Ato select on Over until the repeat mode is canceledTo Watch a Tape Repeatedly Recording and Viewing the Same TV Program Recording a TV ProgramTo Stop Recording To Stop Recording Temporarily Screen and the REC indicator will lightPress Direct channel selection 0-9orCH + Ple ChannelPress Direct channel ONE-TOUCH Timer Recording OTRPress or to select Timer REC SET Timer RecordingPosition, then press Enter Press the or to select the programSpeed as in step Timer REC indicator will lightPress Enter Steps 3 to 6 to set the second programCancel Other Functions for the Timer RecordingTo Cancel a Program If the Program ProgramDisplay the elapsed time Using the Real Time Tape CounterTo View the Counter Display Before playback or recording, press Using Zero Return000000 Press Zero ReturnIndex search TV MonitorTo Monitor a TV Program Connection to Camcorder Duplicating a Video TapeConnection to Another VCR Reception Disturbances Check the following chart before requesting service Problem and Troubleshooting GuideSymptom Cause Possible Solution Power No powerRemote Control Symptom Cause Possible SolutionDepressed To turn on the closed caption RecordingVideo Head Cleaning Video Head CleaningVideo Head Clogging TelevisionLimited One 1 Year Warranty Limited Ninety 90 Day WarrantyLimited Two 2 Year Warranty of Picture Tube Rental UnitsToll Free How to Obtain Warranty ServiceContinental United States contact 04/04 U