PREPARATION
How to Use the Remote Control
This section explains how to get ready for remote control operation.
Setting up the Remote Control
1 Open the battery compartment lid on the rear panel.
2 Install 2 batteries (“AAA” size) following the polarity diagrams.
+ | + |
3 Close the battery compartment lid.
4 Point the remote control at the VCR and press the buttons within the operating range.
Distance: within about 7 m from the front of the remote sensor
Angles: within about 30˚ in every direction
Notes on batteries
•The life of the batteries is about 1 year depending on the conditions of use.
•If the remote control does not operate correctly, replace all batteries with new ones.
•If the remote control is not to be used for a long period of time, remove the batteries to avoid possible damage from battery corrosion.
Caring for the remote control
•Do not expose the remote sensor of the VCR to a strong light source such as direct sunlight or illumination (especially
•Be careful not to spill water on the remote control or to place it on anything wet, and avoid sharp impacts.
10