Toshiba P47LSA owner manual

Page 23

OSD ( On Screen Display ) Control page

Language selection page	Factory Reset page
Only ‘English’ selection is available.	When all reset is necessary, this is the page to reset.

The Light Sensor is placed at the power indicator area, also, wireless remote control receiver is located at the same place.

The purpose of this light sensor is to check the environment light level. If the area was dark, then, display Brightness may not be so much brighter compared to the bright noon time.

Light sensor selection is to make ON-OFF, if this function is necessary or not.

Light Sensor Value adjustment works as to control the picture brightness when after the light sensor worked. Setting this value ‘higher’ will result the intensity high and ‘lower’ the value will come down low brightness in result. The original default value is at 25.

Image 23

Contents LCD Monitor Contents Example of figure Safety InstructionsMay cause death or serious injury*1 May cause injury*2 or material damage*3If not, the unit may fall down and cause an injury Do not place objects on the unit Insert the power plug fully into a 100 － 240V AC outletFollow these precautions for the power cord and plug Do not place the unit in a location subject to vibrationTake measures to prevent the unit from falling down Installation Do not install the unit where humidity is highDo not insert objects inside the unit Do not overload outlets or cables beyond their capacity Precautions for moving the unitNever insert or remove the power plug with wet hands Do not block the ventilation holes on the unitDo not push or jolt the LCD panel Precautions for the remote control batteryConsult your dealer for internal cleaning once a year Features NTSC/PAL/PC SpecificationsBack Names and Functions of Controls UnitFront Side ControlsEffective range Names and Functions of Controls Remote controlBattery Installation About the remote controlPlease check all are supplied Supplied AccessoriesYou can select RGB input from 2 terminals below ConnectionYou can select Video input from 3 terminals below For inquiries and repair InstallationDimension Power button on the remote control Power On/OffMain power switch Menu Function Function of Remote controlVGA DVI Menu display chartDisplay Menu Main MenuColor Menu Position MenuOSD On Screen Display Control PIP ControlPage Input signal selection and its contents Guide to Simple Problem SolvingFactory default setting Symptom Check these thingsVGA Input SignalAbout trademarks Annex