Toshiba P47LSA Do not block the ventilation holes on the unit, Precautions for moving the unit

Page 7

Do not block the ventilation holes on the unit.

The inside of the unit will overheat if the ventilation holes are sealed, which may result a fire.

When installing the unit near a wall, keep the unit at least 10 cm from the wall.

Do not place the unit in a closet or bookshelf where ventilation is poor.

Do not spread a newspaper, tablecloth or curtain over the unit.

Do not place the unit on an unstable surface, such as a rug, or a cushion, etc.

Do not place the unit so that it is facing up or down, or on its side.

Precautions for moving the unit:

When moving the unit, be sure to remove the plug from the wall outlet and disconnect wiring cables between equipment and detach any securing anchors. If not, fire or electrical shock may result if the power cord is damaged, injury may occur by the unit falling down.

When unpacking or carrying the unit, at least two people are needed. Make sure the units upright,

Do not carry the unit with the screen facing up or down.

Handle the unit so as not to jolt the unit.

Do not overload outlets or cables beyond their capacity.

Do not use extension cords.

Electrical shock or fire may result.

Use

Do not pull the power cord when removing the plug from the wall outlet.

If the power cord is yanked, the cord may become damaged and fire or electrical shock may occur. Always hold the plug firmly when removing it.

Never insert or remove the power plug with wet hands.

This may cause electrical shock.

Do not climb or stand on the unit.

It may drop, fall down, break or cause an injury.

If the unit will not be used for a long period of time, remove the power plug from the wall outlet for safety.

If not, in the case of malfunction, it may cause fire.

7

Image 7
Contents LCD Monitor Contents Example of figure Safety InstructionsMay cause death or serious injury*1 May cause injury*2 or material damage*3If not, the unit may fall down and cause an injury Do not place objects on the unit Insert the power plug fully into a 100 - 240V AC outletFollow these precautions for the power cord and plug Do not place the unit in a location subject to vibrationDo not insert objects inside the unit Installation Do not install the unit where humidity is highTake measures to prevent the unit from falling down Do not overload outlets or cables beyond their capacity Precautions for moving the unitNever insert or remove the power plug with wet hands Do not block the ventilation holes on the unitConsult your dealer for internal cleaning once a year Precautions for the remote control batteryDo not push or jolt the LCD panel Features NTSC/PAL/PC SpecificationsBack Names and Functions of Controls UnitFront Side ControlsEffective range Names and Functions of Controls Remote controlBattery Installation About the remote controlPlease check all are supplied Supplied AccessoriesYou can select Video input from 3 terminals below ConnectionYou can select RGB input from 2 terminals below For inquiries and repair InstallationDimension Main power switch Power On/OffPower button on the remote control Menu Function Function of Remote controlVGA DVI Menu display chartDisplay Menu Main MenuColor Menu Position MenuOSD On Screen Display Control PIP ControlPage Input signal selection and its contents Guide to Simple Problem SolvingFactory default setting Symptom Check these thingsVGA Input SignalAbout trademarks Annex