Toshiba 43A61 If you cannot remember your PIN code, Changing the PIN code, Entering the PIN code

Page 28

Using the LOCKS menu	Note:
The LOCKS menu includes the V-chip, CH (channel) Lock, Video	The V-Chip function is available only for the
	U.S. V-Chip system. The Canadian V-Chip
Lock, and New PIN Code functions. You can use these functions only	system is not supported.
after entering the correct PIN code.

Using the TV’s Features

Entering the PIN code

1.Press MENU, and then press x or • until the LOCKS menu appears.

LOCKS

V –CH I P

ENABLE BLOCK I NG

OFF

TV RAT I NG

MPAA RAT I NG

BLOCK I NG OPT I ON

CH LOCK

OFF

V I DEO LOCK

FRONT PANEL LOCK

OFF

NEW PIN CODE

¥ Blocking reset status (to store

¥ When the PIN code is already

a new PIN code):

stored:

Press the Channel Number

Press the Channel Number

buttons (0Ð9) to store a new

buttons (0Ð9) to enter the PIN

4-digit PIN code, and then

code you previously stored,

press ENTER.

and then press ENTER.

2. Press y or z to display the PIN code entering screen.

LOCKS	LOCKS
BLOCK I NG RESET	BLOCK I NG ACT I VE
P I N CODE 1 1 1 0	P I N CODE 1 23 4

If the wrong PIN code is entered, the message ÒIncorrectÓ appears. Enter the code again, and then press ENTER.

If you cannot remember your PIN code

While the PIN code entering screen is displayed, press RECALL four times within 5 seconds. The PIN code will be released (blocking reset status).

LOCKS
V –CH I P
ENABLE BLOCK I NG	ON / OFF
TV RAT I NG
MPAA RAT I NG
BLOCK I NG OPT I ON
CH LOCK
V I DEO LOCK	OFF
FRONT PANEL LOCK	OFF
NEW PIN CODE

Continue to set each item following the steps on the next page.

Changing the PIN code

1.From the LOCKS menu, select NEW PIN CODE.

2.Press the Channel Number buttons (0Ð9) to enter a 4-digit code. The numbers you enter will replace the dashes in the display.

LOCKS

V –CH I P

ENABLE BLOCK I NG

ON

TV RAT I NG

MPAA RAT I NG

BLOCK I NG OPT I ON

CH LOCK

V I DEO LOCK

V I DEO

FRONT PANEL LOCK

OFF

NEW P I N CODE

2 5 6 2

	LIGHT	RECALL POWER
TV
CABLE	MUTE	TV/VIDEO TIMER
	MUTE	TV/VIDEO TIMER

VCR

1	2	3
			CH
4	5	6
7	8	9
		CH RTN	VOL
100	0	ENT
		ADV/
.CAPT	PIP CH		MENU
.CAPT			MENU
C
FAV	ENTER		FAV
RESET		ADV/	EXIT
		ADV/	EXIT

PIP CH

RECALL

Channel Numbers

MENU

ENTER

yzx •

283. Press ENTER. The new PIN code is now active.

Image 28

Contents 50A61, 50A62 Safety Precautions Dear CustomerImportant Safety Instructions InstallationService CareImportant Safety Information Introduction Welcome to Toshiba IntroductionExploring your new TV Connecting your TV Connecting a VCRConnecting a cable converter box Connecting a cable converter box and a VCRConnecting a DVD player or satellite receiver and a VCR Two video cables One set of component video cablesConnecting two VCRs From AntennaConnecting a camcorder Connecting an audio systemConnecting an A/V receiver Connection example of Dolby Pro Logic surround systemUsing the remote control Preparing the remote control for useInstalling the remote control batteries Using the remote control with a VCR or a cable TV converterUsing the Remote Control VCR code table Brand name Code numberCable TV converter code table ABCLearning about the remote control Setting up your TV Press Exit to close an on-screen display instantlySelecting the antenna input Changing the on-screen display languagePress x or to highlight your desired language Programming channels automatically Adding channels to the TV’s memoryPress z to select CH Program Changing channels Changing channels using SpeedSurfAdding and erasing channels manually Press x or to display the center convergence menu Adjusting the color convergencePress Exit twice to close the convergence menus Using the TV’s features Adjusting the channel settingsSwitching between two channels Programming your favorite channelsUsing the TV’s Features Labeling channelsChannel Number Into the program block mode. See ÒUsing the V-CHIP menuÓ on Watching picture-in-picture PIPChanging the position of the small picture Switching the main and small picturesFreezing the small picture Changing the PIN code If you cannot remember your PIN codeEntering the PIN code Using the V-CHIP menu TV Rating Independent rating system for broadcastersMpaa Rating Independent rating system for movies Movie ratings you can lock are described as followsLocks menu From the Locks menu, selectLocking channels Unlocking programs temporarilyLocking the front panel buttons Locking video inputsTo unlock the front panel buttons Select OFF in above Adjusting the picture Adjusting the picture qualityTo adjust the picture quality Selecting the picture modesUsing the flesh tone feature Using the noise reduction featureTo turn off the flesh tone feature Highlight OFF in above Saving new preferencesSelecting the color temperature Resetting your picture adjustmentsWatching video input Selecting the video input labelsUsing the closed caption feature Closed caption feature has two optionsTo turn off the closed-caption feature, highlight OFF To view text, highlight T1, T2, T3, or T4Setting the sleep timer Setting the clockPress Enter to start the timer To display the time on-screen Press RecallMuting the sound Adjusting the soundSelecting stereo/SAP broadcasts Using the surround sound feature Adjusting the sound quality Resetting your audio adjustmentsUsing the sub-bass system SBS Turning off the built-in speakersTo turn off the SBS Highlight OFF in above To turn on the built-in speakers Highlight on in aboveTo turn off the StableSound feature Highlight OFF in above Using the StableSound featureSelecting the Audio OUT sound Selecting the background of the menu display Viewing the demonstration modeDisplaying on-screen information Understanding the auto power off feature Understanding the last mode memory featureSpecifications AppendixTroubleshooting Limited United States Warranty Limited Canada Warranty Appendix Index Channel programmingManufactured by