Transition to the PC mode, PC Mode Menu structure

Start Up

As your LCD-TV unit also enables VGA applications, it can also be used as a PC monitor.

Transition to the PC mode

In order for the LCD-TV to switch to the monitor (PC) mode, you can use the PC button on your remote control. In order to switch from the monitor mode back to the TV mode, use the TV button on your remote control.

NOTE 1: When the unit is switched to the monitor mode, the EXT2, can be heard from the speakers. When switched to this mode, the VOL+/VOL- and MUTE buttons will be functional. NOTE 2: When the unit is in monitor mode, the Stand-by button is functional. When the unit is switched back on from the stand-by function, it will open in the TV mode.

PC Mode MENU structure

When you press the () button on your remote control while the unit is in the PC mode, the features available in the PC mode will appear on screen as the PC MENU. In order to make the necessary adjustments in this menu, you can use

the	right-left,	up-down movement
(	)/( ), (	)/(	) buttons on your
remote control.

TIME: ADC’s time setting

PHASE: ADC’s phase setting

H.POSITION: Horizontal position setting V.POSITION: Vertical position setting AUTOMATIC CONFIGURATION: The most suitable geometric settings in

accordance to the entry mode is configured by this function. For this application, highlight the AUTOMATIC CONFIGURATION option and press the OK button.

Warning Messages:

1.NO SIGNAL: There is no VGA connection. Under these circumstances the on screen display will be “NO SIGNAL”. The message will be on screen for 15 seconds and if a suitable VGA attachment is not made to the indicated area, then the unit will switch itself to the POWER SAVING mode in order to protect the unit panel.

2.OUT OF RANGE: If the resolution application is not one of the graphic entry modes, then the on screen display will be “OUT OF RANGE”. The message will remain on screen until the necessary graphic entry mode is applied.

Important Cautions:

1.When a VGA mode is displayed for the first time, an AUTOMATIC CONFIGURATION application may be necessary.

2.According to the VGA power Saving standards, when there is no signal, for 15 seconds an on screen display of “NO SIGNAL” is shown after which the unit switches itself off in a 30Watt power saving mode.

If you switch to the monitor model after adjusting the TIMER function available under the Special Features menu, the timer function and program switch will no longer function, however the automatic shut-down application will continue to function.

ENGLISH -24-