CHANGING THE DEFAULT SETTINGS
•Press the LEFT/RIGHT ARROW buttons to set the distance difference.
•Press the SELECT button to confirm the settings and return to the Speaker Setup Page.
•The channel delay is the difference between the distance from the listener to the front speakers and the distance from the listener to the speaker to be configured.
•The distance between the surround speakers and the listener must be less than or equal to the distance from the front speakers and the listener.
...........................................................................................................................................................................
CHANNEL TRIM
Use this to set the volume of each individual channel.
•Press the LEFT/RIGHT arrow buttons to select the channel to be adjusted.
•Press the UP/DOWN arrow buttons to raise or lower the volume of the selected channel.
•Press the SELECT button to confirm the settings and return to the Speaker Setup Page.
...........................................................................................................................................................................
AUDIO DELAY (Default: 00)
Use this to synchronize the audio and video signal.
•Adjust the audio delay by
•Press the LEFT/RIGHT arrow buttons to increase or decrease the Audio Delay.
AUDIO SETUP
Choose Audio Setup and press ENTER. Use the UP , DOWN , LEFT , and RIGHT cursor buttons to navigate the options within Video Setup. When making changes, navigate to the desired selection and press ENTER. Press the LEFT arrow to return to the list of options within Audio Setup. To exit AUDIO Setup, press the LEFT arrow to navigate back to the top icon setup menu.
AUDIO SETUP OPTIONS:
...........................................................................................................................................................................
DIGITAL OUTPUT
The options are:
•RAW (default) – Use this setting for Dolby Digital movie playback.
•PCM (Pulse Code Modulation) – Digital out for CDs.
...........................................................................................................................................................................
LPCM RATE
Use this to set the maximum Linear PCM output frequency. The options are:
•48K (default) – Supported by most equipment.
•96K – Better sound can result. Ensure that the receiver/amplifier can support it.
•192K – The best sound possible. Ensure that the receiver/amplifier can support it.
21