Pioneer DV-C302D operating instructions Rear Panel

Rear Panel

1 2 3 4 5 6

				Y
				COMPONENT
				VIDEO OUT
CONTROL	VIDEO OUT	S-VIDEO OUT	VIDEO	PB
IN			OUT
			SELECT
				PR
				AUDIO OUT (2CH)		AUDIO OUT (5.1CH)
DIGITAL OUT				1	2	FRONT	SURROUND
OPT.				L		L	CENTER
				R		R	SUB
							WOOFER
							AC IN

9 8 7

1CONTROL IN jack

Use to connect this player to another component bearing the Pioneer ë mark. This lets you control this unit as though it were a component in a system. Player operations are then performed by pointing the remote control at the component that the player is connected to (page 19).

5AUDIO OUT (2 CH) jacks

Use to output two-channel audio (analog) to the audio stereo inputs on a TV or stereo amplifier. If you are connecting to a receiver that has both digital and analog input jacks for DVD player connection, it may be beneficial to make both connections (pages 18).

2VIDEO OUT jack

Connect to the video input on a TV or monitor or AV amplifier or receiver with video input capability. When using this jack, be sure to set VIDEO OUT SELECT to the left position (page 19).

3S-VIDEO OUT jack

If your TV or monitor has an S-video input, clear picture reproduction is possible by connecting the player to your TV or monitor via the S-video jack. When using this jack, be sure to set VIDEO OUT SELECT to the left position (page 19).

4COMPONENT VIDEO OUT jacks

If your projection monitor, projector or similar component has component video inputs, you can produce a higher quality picture on your projection monitor or projector by connecting to the component video outputs on this unit. When using these jacks, be sure to set VIDEO OUT SELECT to the right position (page 19).

6AUDIO OUT (5.1 CH) jacks

Use to output 6 discrete audio channels of decoded digital audio to a receiver or amplifier with discrete audio inputs (page 18).

7AC IN power cord connection terminal Use to connect the power cord to the wall outlet (page 15).

8VIDEO OUT SELECT switch

Use to set which output is used to output the video signals. Select either video/S-video or component video signal output depending on the connections you make (page 19).

9DIGITAL OUT jacks (coaxial, optical (OPT.)) Use to output the digital audio signal recorded on discs. You can output the digital signal via either coaxial or optical output jack to an AV amplifier or receiver (page 17).

12