Audio is not output or is distorted.
The Setup screen Audio 1 menu [96kHz PCM Out] setting is set to “96 kHz”. Digital output is prohibited on some discs.
\Be sure to make analog audio connections as well as digital connections (pages 17 and 18).
The disc is dirty.
\Refer to “Disc Care” (page 55).
The connection plugs are not inserted fully into the terminals or are not connected.
\Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\Check that the plugs and terminals are wiped clean of dirt, etc.
Audio cable connection is wrong.
\Check to make sure that the audio cables are connected correctly (pages 17 and 18).
Connection is made to the stereo amplifier‘s PHONO input terminal.
\Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\Press PLAY 3 or 8 to exit the pause mode.
Stereo amplifier operation is incorrect.
\Check input (CD, AUX, etc.) selector to determine if it is selected for DVD playback.
The DVD is recorded in DTS audio.
\DTS audio is only output from the digital output jacks. Connect the digital output on the player to the digital input on a receiver or amplifier with a built in DTS decoder to hear DTS audio.
Noticeable difference in DVD and CD volume.
DVDs and CDs use different recording methods.
\This is not a malfunction.
Audio mix does not sound right or sounds imcomplete (for example, the dialog of the actors cannot be heard.
Audio output selection is incorrect.
\When 5.1 channel audio output is selected, the front right (R) and left (L) audio channels are output from the 2 channels jacks. Similarly, when 2 channel audio output is selected, the stereo channels are output from the front right (R) and left (L) audio channels of the 5.1channel jacks. Check that the correct output is selected (page 31).
Caution
Static electricity or other external influence may cause malfunctioning of this unit. In this case, unplugging the power cord and then
INFORMATION | ADDITIONAL |
59