Pioneer DV-410V-K Picture disturbance during, Playback or the picture is, Dark, Distorted

09

46

Problem	Remedy
Picture disturbance during	• This player is compatible with Macro-Vision System copy guard.
playback or the picture is	Some discs include a copy prevention signal, and when this type of
dark.	disc is played back, stripes etc., may appear on some sections of
	the picture depending on the TV. This is not a malfunction.
	• Due to the player’s copy protection circuits, connection of this
	device through a VCR or an AV selector may prevent recording or
	cause picture problems. This is not a malfunction.
	• Check whether the TV system is properly set (page 44).
No audio, or audio is	• No audio is output during slow motion playback or when
distorted.	scanning discs other than audio CDs.
	• Some DVD discs do not output digital audio: Switch your
	amplifier to the player’s analog outputs.
	• Check that the disc is free from dust and dirt, and that it is not
	damaged (page 42).
	• Check that all interconnects are firmly inserted.
	• Check that the plugs and terminals are free of dirt, oxide, etc. and
	clean if necessary. Also check the cable for damage.
	• Make sure the player’s output is not connected to the amplifier’s
	phono (turntable) inputs.
	• Check your amplifier/receiver’s settings (volume, input function,
	speaker settings, etc.).
The analog audio is OK, but	• Make sure that the Digital Out setting is set to On (page 35).
there appears to be no	• Check that the Dolby Digital Out, DTS Out and MPEG Out
digital audio signal.	settings (page 35) are suitable for your amplifier/receiver — check
	the instruction manual that came with your amplifier/receiver.

Noticeable difference in DVD • This is due to differences in the audio format and is not a

and CD volume.	malfunction.
Cannot play multi-channel	• Check that the Dolby Digital Out, DTS Out and MPEG Out
audio.	settings (page 36) are suitable for your amplifier/receiver — check
	the instruction manual that came with your amplifier/receiver.
	• Check the audio options available from the disc menu.
Cannot listen to	• Make sure that 96kHz PCM Out is set to 96kHz (page 36).
high-sampling rate audio	• As a copy-protection measure, some DVDs do not output 96 kHz
through the digital output.	audio. In this case, even if set to 96kHz, the player automatically
	outputs the audio at 48 kHz. This is not a malfunction.

Cannot output 96 kHz or • Check that 96kHz PCM Out is set to 96kHz (page 36).

88.2kHz digital audio. • Some discs are digital copy protected and do not output high sampling rate digital audio. In this case the output is automatically downsampled.

No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier or decoder using a digital audio cable, set DTS Out to DTS > PCM/Off (page 36). If you do not do this, noise will be output when you play a DTS disc.

•If this unit is connected to a DTS-compatible amplifier or decoder using a digital audio cable, check the amplifier settings, and that the cable is properly connected.

The audio recorded on a • If the audio is switched to [2] when playing a Super VCD that Super VCD disc is not output contains only one stereo soundtrack, there may be no sound at all.

properly. Press AUDIO to change the soundtrack.

En