9.If most of the buttons function press the OK button l to save the setting. In the LCD display q "OK" appears.
Subsequently the menu will close automatically.
10.If, however, none or only a few of the buttons function select with the 5 or 6 button t the next code and test again as described in step 8.
11.With the EXIT button y you will move one level upwards
in the menu.
Repeat these operational steps for all devices that you would like to control with the remote control.
Programming by manual code input
In this mode the remote control can be programmed by direct input of a code number. You can obtain the necessary code number from the enclosed manufacturers directory with device code list. In the event that the new code is invalid the last valid programmed code will be restored.
1.Press the device button e for the device that you want to programme the remote control.
2.Hold down the S button r for a little longer than 3 sec- onds.
3.In the LCD display q "CODE SETUP" appears. Press the OK button l. "ENTER CODE" now appears in the LCD display q. To access this function press the OK button l.
4.In the LCD display q appears the presently used code for the selected device. Now the first digit of the code blinks and waits for your code input. Enter the new four digit code via the number buttons o.
5.If the entered CODE is valid the code will be saved. In the LCD display q "OK" appears briefly. Subsequently the menu will close automatically. In the event of failure the LCD display q shows briefly "ERROR" and waits for a new code entry. Then you repeat step 4.
6.With the EXIT button y you will move one level upwards in the menu.
Programming by automatic code search
This process can take several minutes per device since all codes for the selected device have to be gone through. Therefore this method should only be used when the device cannot be programmed via brand code search or direct code input or if your device is not listed at all in the manufac- turers directory with device code list.
Follow the steps listed below to carry out programming by means of the automatic code search.
- 12 -