6.If the specified device is equipped with a volume control, “SUCCESS” will be displayed briefly and the menu will close. From now on the volume control functions on the device just specified.
7.If this device is not equipped with its own volume control the URC will not allow this selection and shows “VOLUME ERROR”. Even then the menu will close. The volume con- trol will then continue to function on the former device.
You can also deactivate the global volume control for specific devices.
1.For this purpose select in the VOL/MUTE SETUP with the or button t the function MODE VOL SET and confirm with the OK button l.
2.Now press the device button e for the device that is to be excluded from the global volume control. The LCD display q shows „SUCCESS“ and the global volume control is deactivated if the URC is working in the opera- tional mode of one of the selected devices.
You can also cancel the settings again in VOL/MUTE SETUP.
1.For this purpose select in the VOL/MUTE SETUP with the or button t the function VOL/MUTE RESET and confirm with the OK button l.
2.The LCD display q prompts you, with CONFIRM RESET, to a confirmation which is done by pressing the OK but- ton l. Press the OK button l If you want to delete the settings, the SUCCESS indicator then confirms the dele- tion. Otherwise you press the EXIT button y to abort the deletion.
Note:
If you press, in this menu, the EXIT button y the entire menu will close immediately.
Setting the lock function
With the lock function you can block access to all setup menus.
1.Hold down the S button r for a little longer than 3 sec- onds.
2.With the or button t select „SYSTEM SETUP“ and confirm with the OK button l.
3.With the or button t select “LOCK SETUP and confirm with the OK button l. The LCD display q shows the current settings.
4.With the or button t now select between „LOCK“ (Block) or „UNLOCK“ (Unblock).
5.With the OK button l you save the setting. In the LCD display q „LOCK SETUP“ then appears again.
- 16 -