Onkyo SP504 Audio Menu, Scart Output Setting European model only, Digital/HDMI Audio Out

Page 48

Configuring the DVD player—Continued

SCART Output Setting (European model only)

With this setting you can select the video format to be used for the SCART AV CONNECTOR: RGB, S-Video, or composite video. Before changing this setting, refer to your TV’s manual to see if its SCART input can accept video signals in these formats.

Composite (default): Composite video offers stan- dard quality.

S-Video:S-Video offers the next best picture quality.

RGB: This format offers the best picture quality.

Notes:

•If you select a format that is not supported by your TV, the setup menu may disappear from the screen. If this happens, switch off your equipment, connect the DVD player to your TV with a composite video or S-Video cable, and then change this setting.

•When RGB is selected, nothing is output by the com- ponent video output and HDMI output.

Audio Menu

Digital/HDMI Audio Out

With this setting you can configure the optical, coaxial, and HDMI digital outputs.

All (default): Dolby Digital and DTS signals are out- put as they are.

PCM: Dolby Digital and DTS signals are down mixed to 2 channels and output as PCM.

Off: No digital signals are output.

Note:

• MPEG is output as PCM regardless of this setting.

Linear PCM Out

With this setting you can configure the DVD player to output digital audio with higher sampling rates (e.g.,

88.2kHz, 96 kHz) as it is or to down sample it to 48 kHz or below.

If the AV component you connect to the DVD player’s digital audio outputs supports 96 kHz digital audio, select Down Sample Off. Otherwise, select Down Sam- ple On.

Down Sample On: 196 kHz and 96 kHz sources are down sampled to 48 kHz, and 176.4 kHz and

88.2 kHz sources are down sampled to 44.1 kHz.

Down Sample Off (default): Sources are output as they are.

Notes:

•Some copy-protected DVD-Video discs may use

96 kHz digital audio only for D/A conversion to the analog audio outputs.

•With some discs, even if you select Down Sample Off, the digital audio will be down sampled, and in some cases may not be output by the DVD player’s digital audio outputs.

Speaker Configuration

With these settings, you can specify which speakers are connected and their sizes. These settings only apply to the DVD player’s analog multichannel output. If you connect to only the FRONT/D.MIX L/R jacks, set the Subwoofer, Center Speaker, and Surround Speaker set- tings to Off.

Note:

•The Speaker Configurations have no effect on 192 kHz/176.4 kHz DVD-Audio.

•To use the Speaker Configuration settings with SACD playback, in the SACD Audio Setup, select PCM.

■Subwoofer

On (default): Select if a subwoofer is connected.

Off: Select if no subwoofer is connected.

■Front Speaker

Large: Select if the front speakers are large.

Small (default): Select if the front speakers are small.

Note:

•If the Subwoofer setting is set to Off, this setting is fixed at Large and cannot be changed.

■Center Speaker

Large: Select if the center speaker is large.

Small (default): Select if the center speaker is small.

Off: Select if no center speaker is connected.

Notes:

•If the Front Speaker setting is set to Small, the Large option cannot be selected.

•The Center Speaker and Surround Speaker settings can only be set to the same size.

■Surround Speaker

Large: Select if the surround speakers are large.

Small (default): Select if the surround speakers are small.

Off: Select if no surround speakers are connected.

Notes:

•If the Front Speaker setting is set to Small, the Large option cannot be selected.

•The Center Speaker and Surround Speaker settings can only be set to the same size.

48

Page 47 Page 49
Image 48
Page 47 Page 49
Contents DV-SP504/ DV-SP504E Important Safety Instructions AvisPrecautions PowerInstalling this Unit Precautions Label on the right is applied on the rear panelFCC Information for User Supplied Accessories For models having a power cord with a polarized plugMake sure you have the following accessories Sur les modèles dont la fiche est polariséeFeatures IntroductionContents Introduction Disc NotesSupported Discs Function SupportMP3/WMA/JPEG Compatibility About WMAAbout DivX DivX video compatibilityCleaning Discs Handling DiscsStoring Discs CopyrightBefore Using the DVD player Installing the BatteriesUsing the Remote Controller Open the battery compartment, as shownFront & Rear Panels Front PanelFront & Rear Panels DisplayRear Panel North American model European modelOther models Surr Mode switch AV Connector European model onlyAudio Output 20, 22 JackRemote Controller Search button 34 Memory buttonRepeat button B buttonConnecting the DVD player AV Cables & ConnectorsConnecting the DVD player Video Output/Video Setting MatrixAudio Output/Audio Setting Matrixes Digital Audio Output/Audio Setting MatrixBasic Setup Before Making Any ConnectionsOptical Digital Outputs RCA AV Connection Color CodingUsing S-Video Using Scart European model onlyUsing Component Video Compatibility of this unit with progressive-scan TVsConnecting to an AV Receiver Connecting the Analog OutputConnecting the Digital Output Before ConnectingConnecting -compatible Components Connecting the Multichannel Analog OutputYou can use three stereo audio cables for this If Your AV Receiver has a 7.1-channel Analog Audio InputConnecting your Hdtv or AV receiver with an Hdmi Input What is HDMI?Using Hdmi Hdmi & the DVD playerUsing the Multiroom Control Kits North American model only Using a Multiroom Kit with Other ComponentsUsing a Multiroom Kit with a Cabinet Connecting the Power/Turning on the DVD player DVD player turns on and the Standby indicator turns offPlug the supplied power cord into Power outlet on the wallInitial Setup First Time SetupStarting, Pausing & Stopping Playback Playing DiscsPlaying Discs Select Next & Previous track/chapterStop To stop playback, press the Stop ButtonForward Frame-by-Frame Playback Fast Forward & ReverseSlow-motion Playback Navigating DVD & VCD Disc Menus Navigating CDs & Super Audio CDsNavigating MP3, WMA & DivX Discs Viewing a Slideshow of Jpeg Images Advanced Playback Press the Play or EnterButton to start playback Specified title, chapter, or trackAdvanced Playback Searching by TimeTime Specified timeRepeat Playback To cancel random playback, use Random PlaybackRandom button to select Random OffMemory Playback Adding New Items to the ListLast Memory Deleting Items from the ListEditing Steps Zooming Selecting Camera AnglesSelecting Soundtracks Selecting SubtitlesDisplaying Information Hdmi and Progressive Settings Setting the HdmiSelecting Progressive or Interlaced Menu Setting Description Configuring the DVD playerPicture LanguageUsing the Onscreen Setup Menus Press the Setup buttonWhen you’ve finished, press Setup button againView Mode Hdmi Output SettingProgressive Setting Picture MenuHD Resolution HD Jpeg modePAL Output Setting Not North American and Korean models Video Black LevelScart Output Setting European model only Audio MenuDigital/HDMI Audio Out Linear PCM OutCenter Delay and Surr. Delay Test ToneDynamic Range Control Dolby Digital only Pro LogicLanguage Menu Selecting Other Languages Menu Language, Audio LanGuage, or Subtitle menu, Then press EnterDisplay Menu Operation Setting Menu Setting the Parental LockChange the Security Code DVD Priority Contents Sacd Priority ContentsAuto power off DivX RegistrationResetting the player Disc Content OrganizationAdjusting the Display Brightness Additional informationGlossary Additional informationMP3, WMA, Jpeg & DivX Files ISO 9660 format Mpeg videoPBC PlayBack Control Video CD only PCM Pulse Code ModulationTroubleshooting Symptom Possible cause RemedyTroubleshooting No Sound from the Hdmi OUT?Can’t view Jpeg files? Hdmi Status Mode No picture from the Hdmi connectionDisplayed ID Message No sound from the Hdmi connectionSpecifications GeneralMemo Onkyo Europe Electronics GmbH Onkyo Europe UK Office
Top Page Image Contents