Plasmon LF 6602 user manual Inspecting the LF, Repacking the LF

INSPECTING THE LF 6602

The following items should be included in the LF 6602 carton:

•One LF 6602

•One daisy chain SCSI cable

•One primary AC cord

•One User Manual

•One Manual Release Tool

Accessories such as a SCSI terminator, a SCSI cable and optional LM 6000 media cartridges, if ordered, will accompany the LF 6602 in a separate carton.

After unpacking the LF 6602, check for:

•damage to the cabinet

•dislocated or broken controls and indicators

Report all discrepancies, missing items and damaged equipment to your supplier. If condensation exists on the drive, allow the moisture to evaporate by exposing the LF 6602 to the operating environment for at least 6 hrs before powering on the unit.

REPACKING THE LF 6602

The LF 6602 should be repacked using the original packing materials. Close the baseplates of each drive before repacking the LF 6602 as explained in step 2) of the following procedure.

CAUTION

Shipping the LF 6602 without closing the drives' baseplates may result in damage to the drives which is not covered under warranty.

1)Ensure that the media cartridge is unloaded from the drive into the shuttle. Remove all cartridges from the shuttle.

2)On each drive's DOC, select the "Park Drive" option, as explained in the Viewing Diagnostic section, to prepare the LF 6602 for shipment.

If the drive is not functional, follow these steps to manually close the baseplates:

a.) Ensure that the primary AC power cord is disconnected from the wall outlet and that the power switch on each drive is set to the OFF position ( O ).

b.) With a T-15 screwdriver, loosen the four screws that secure the shipping bracket to the LF 6602 chassis (see next figure).

97654438 E Page 27