Turning on
Connecting the POWER
The 
ON). When the power cord is plugged in for the first time, the
POWER 
STANDBY/ON
STANDBY indicator
Notes
•Make sure that all appropriate connections have been completed as described on pages 14 to 16.
•Turning on the DVD Changer may cause a momentary power surge, which might interfere with other electrical equipment such as computers. To prevent interference, use a wall outlet on a different circuit.
1 Plug the power cord into the
power outlet on the wall.
2 Press POWER to switch on |
|
the main power. | STANDBY/ON |
The DVD Changer enters standby mode.
The STANDBY indicator blinks for about 10 seconds, then lights. While the STANDBY indicator is blinking, operation buttons will not function.
Notes
•The buttons on the remote controller do not operate if the POWER switch is set to OFF.
• To switch off the main power, press POWER again.
3 Press
STANDBY/ON on the DVD Changer or remote controller.
The DVD Changer turns on and the STANDBY indicator turns off. It takes several seconds to read the disc in the disc tray.
Notes
•You can turn on the DVD Changer by pressing 0or £/8.
• | To put the DVD Changer in the standby mode, press |
| STANDBY/ |
| ON on the DVD Changer, or remote controller. Be sure to set the | ||
| volume to minimum before putting the DVD Changer in the | ||
| standby mode for the next use to avoid sudden loud sound | ||
| reproduction. | ||
• | While the STANDBY indicator lights up, the DVD Changer can | ||
| receive signals from the remote controller. However, if you press | ||
| POWER on the DVD Changer to switch off the main power, the | ||
| remote controller cannot be used to turn on the DVD Changer. | ||
•Setting the STANDBY button to standby does not shut off the power completely.
17