I N S T A L L A T I O N
oAudio Setup Page > Digital Output to “Raw” o Audio Setup Page > HDMI Audio to “Auto”
5.1CH | |
Front Speaker | Large |
Center Speaker | Large |
Rear Speaker | Large |
Subwoofer | On |
Channel Delay |
|
Digital Output | Raw |
LPCM Rate | 48KHz |
Audio Tone | 00 |
Pro Logic II |
|
Dolby Digital Setup |
|
Channel Trim |
|
Audio Delay | 05 |
HDMI Audio | Auto |
In this configuration you can enjoy all audio formats using the HDMI connection.
NOTE
HDMI is a wonderful thing. A single cable can transport both audio AND video from your DVD player to your display. Be aware, however, that HDMI is an evolving standard, and there could be compatibility issues. The OPPO
Multi-Channel Analog Audio to Receiver
If your DVD player is connected to an A/V receiver through the 5.1ch analog audio jacks using 6 RCA cables (as described in “Method 4” on page 11), you can play all supported audio formats and listen to it with your A/V receiver and surround systems. The following setup options are recommended:
•Set the Speaker Setup Page > Down-mix to “5.1CH”.
•Set the speaker size and subwoofer properly according to your actual audio hardware.
•Enable or select the
5.1CH | |
Front Speaker | Large |
Center Speaker | Large |
Rear Speaker | Large |
Subwoofer | On |
Channel Delay |
|
Using the
Coaxial or Optical Digital Audio to Receiver
If your audio connection is as described in “Method 5” on page 12 of this guide, and the A/V receiver support Dolby Digital and DTS decoding, the following setup options are recommended:
19