OPPO Digital DV-987HD user manual Stereo Analog Audio to Receiver

I N S T A L L A T I O N

•Set the Audio Setup Page > Digital Output to “Raw”. This will ensure the original Dolby Digital and DTS audio stream will be sent to the receiver for decoding. Stereo audio content will also be sent in digital format.

--- Audio Setup Page ---
Digital Output	Raw
LPCM Rate	48KHz
Audio Tone	00
Pro Logic II
Dolby Digital Setup
Channel Trim
Audio Delay	05
HDMI Audio	Auto

Due to bandwidth limitation of the technology and copyright restrictions, unfortunately it is impossible to send high-resolution multi-channel digital audio from a source like SACD or DVD-Audio to the receiver using this connection method. To enjoy SACD or DVD-Audio in their full resolution, please use the HDMI connection if you have a receiver that handles HDMI audio and use multi-channel outputs if you do not.

Stereo Analog Audio to Receiver

If you primarily listen to stereo contents or your receiver only offers stereo audio connections, please use the analog RCA-style cables to connect the MIXED L/R output of the DVD player to your receiver, as described in “Method 6” on page 13 of this guide. Depending on whether the receiver has surround speakers and supports Dolby Pro Logic II decoding, you may use one of the following audio configurations:

•No Surround Speakers: If the audio system does not have surround speakers, please set the Speaker Setup Page > Down-mixto “Stereo” or “V. Surround”.

--- Speaker Setup Page ---

Down-mix	Stereo
Front Speaker	Large
Center Speaker	Small
Rear Speaker	Small
Subwoofer	Off
Channel Delay

•Surround Speakers and Dolby Pro Logic II Support: If the audio system has surround speakers and Dolby Pro Logic II Surround support, please set the Speaker Setup Page > Down-mix to “Lt/Rt”.

--- Speaker Setup Page ---

Down-mix	Lt/Rt
Front Speaker	Large
Center Speaker	Small
Rear Speaker	Small
Subwoofer	Off
Channel Delay

20