NAD S 570 owner manual Connecting to a TV Directly, Español Nederlands Deutsch Français English

Introduction

CONNECTING TO A TV DIRECTLY

S-VIDEO of the S570 to the S-Video of the TV

COMPONENT VIDEO OUT Jacks of the S570

to the component video of the TV

SCART/RGB OUT Jack of the S570 (EURO version) to the 21-

pin SCART of the TV

Composite VIDEO OUT Jack of the S570

to the composite video of the TV

TV or monitor with audio/video inputs

ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

NOTE

The switch labeled VIDEO OUTPUT S-VIDEO-SCART/RGB is used to select between one of two outputs, the S-VIDEO and the 21-pin SCART/RGB. If one intends to connect to the S-VIDEO then slide the switch to S-VIDEO; if to the 21-pin SCART/RGB, then slide the switch to the SCART/RGB position.

A 75-Ohm video and audio cables are supplied with the S570. SCART and S-Video cables can be purchased from your local NAD retailer.

WARNING

Do not set the Digital Audio Output of this DVD player to Analogue Off unless you are connecting the DIGITAL OUT jack of this DVD player to a TV that is equipped with an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers. (Refer to Initial Setup Settings, Audio)

NOTES

•Switch the power off on the S570 before switching the SCART/S-VIDEO switch position.

•Refer to the owner’s manual of your receiver as well.

•Before you connect the S570 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

•Depending on your Digital sound decoder, the decode rate may be 96 or 48K.

•The output sound of the S570 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

•Turn off the receiver before you connect or disconnect the S570’s power cord. If you leave the receiver power on, the speakers may be damaged.

SVENSKA PORTUGUÊS ITALIANO

23