Alpine IVA-D105 owner manual General Setup Operation

GENERAL Setup

General Setup Operation

To display the General mode screen:

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2Keep pushing the foot brake and release the parking brake once then engage it again.

3When the parking brake is engaged for the second time, release the foot brake.

•For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the General mode operation has been released. Engaging the parking brake can reactivate the General mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To display the General mode screen.”

Each time the ignition is turned OFF, perform the procedure of “To display the General mode screen.”

Displaying the Time

The clock indication on the monitor display is turned on or off respectively.

Setting item: CLOCK

Setting content: OFF / ON

Setting the Time

Setting item: CLOCK ADJUST

Further setting items : HOUR / MINUTE / TIME ADJUST

Setting content: 1-12 / 0-59 / RESET

HOUR: Adjust the hour.

MINUTE: Adjust the minute.

RESET: If the clock shows less than 30 minutes past, the minute will be “0”; more than 30, the hour advances.

•The clock-adjusting mode is canceled when the power is turned off, when [RETURN] is touched.

Setting Daylight Saving Time

Setting item: DAYLIGHT SAVING TIME

Setting content: OFF / ON

ON: Place the Summer Time mode ON. The time advances by one hour.

OFF: Return to the ordinary time.

The following steps 1 to 4 are common operations to each “Setting item” of GENERAL Setup. Refer to each section for details.

1 Touch [SETUP] on the main source screen.

The SETUP selection screen is displayed.

2 Touch [ ] of GENERAL SETUP.

The GENERAL setup screen appears.

3 Touch [ ] or [ ], etc., of the desired item to change its setting.

Setting items:

CLOCK / CLOCK ADJUST / DAYLIGHT SAVING TIME / DEMONSTRATION / BEEP / AUTO SCROLL / LANGUAGE SELECT / LED DIMMER LEVEL

4 Touch [RETURN] to return to the previous screen.

•Immediately after changing the settings of General Mode (While the system is writing data automatically) do not turn the ignition key (engine key) to OFF.

Otherwise, the settings may not be changed.

Demonstration Function

This unit is equipped with a demonstration function capable of showing basic operations of respective sources on the monitor display.

Setting item: DEMONSTRATION

Setting content: OFF / ON

ON: Turns on the demonstration mode to show the basic operations.

OFF: Turns off the demonstration mode.

•The demonstration operation is automatically repeated until the function is turned off.

Sound (Beep) Guide Function

Setting item: BEEP

Setting content: OFF / ON

ON: Activate the Sound Guide mode.

OFF: Deactivate the Sound Guide mode. The sound guide beep will not be produced when a button on the unit is pressed.

•A beep always sounds when opening or closing the monitor, regardless of this setting.

35-EN