Integra DPS-7.3 instruction manual Display, Rear panel

■Display

1 2 3 4 56 7 8 9 0 -

=	#
~	@
!

1 ŸD indicator

2Inserted disc indicator

3 TITLE indicator

4 GUI (Graphical User Interface) indicator

Indicates an on-screen menu operation is being performed. On-

screen menu helps you set up the player.

5PBC indicator

6CHP/TRACK indicator

7 Angle icon indicator

8REPEAT indicator

9TOTAL/REMAIN indicator

0LAST indicator -COND indicator

=PROGRESSIVE indicator ~DTS indicator

!£/8 indicator

@Multifunctional indicator

(e.g. operating status and error messages)

#L, C, R, LFE, LS, S, RS and D.MIX indicator

■Rear panel

1 2 3 4 5 6 7 8 9 0 -

IR

OUT

IN

CH1

CH2

RS-232

VIDEO OUTPUT ANALOG OUTPUT DIGITAL OUTPUT

Y	PB	PR	VIDEO	CH 1	CH 2 FRONT SURR CENTER	REMOTE
					OPTICAL	CONTROL
				L		COAXIAL
				R
	COMPONENT		S VIDEO		SUB
					WOOFER

AC INLET

DVD AUDIO/VIDEO PLAYER

MODEL NO. DPS-7.3

1IR IN

If the DPS-7.3 is located inside a rack or cabinet that will not allow infrared beams to reach the IR sensor, you will need to connect a remote sensor to IR IN input to be able to use the remote controller. Then install the remote sensor in an unblocked location where you can easily point the remote controller.

2VIDEO OUTPUT COMPONENT CH 1/CH 2 jacks

[14]

If your TV or monitor has component video inputs, you can produce a higher quality picture on your TV or monitor by connecting to the component video outputs on this unit.

3RS-232 port

This port is to be used in conjunction with an external controller to control the operation of the DPS-7.3 using an external device.

4VIDEO OUTPUT VIDEO jack [13]

Connect to the video input on a TV or monitor or AV amplifier or receiver with video input capability.

5VIDEO OUTPUT S VIDEO jack [14]

If your TV or monitor has an S-video input, clear picture reproduction is possible by connecting the player to your TV or monitor via the S-Video jack.

You can switch between [S1] and [S2] S-video output from the Setup menu.

6ANALOG OUTPUT CH 1/CH 2 jacks [13, 14]

Use to output two-channel audio (analog) to the audio stereo inputs on a TV or stereo amplifier.

7ANALOG OUTPUT FRONT/SURR/CENTER/

SUBWOOFER jacks [15]

Use to output 5.1 channel audio (analog) to the 5.1 channel discrete inputs on an amplifier. If you are connecting to a receiver that has both digital and analog input jacks for DVD player connection, it may be beneficial to make both connections.

8DIGITAL OUTPUT OPTICAL jack [15]

Use to output the digital audio signal recorded on discs. You can output the digital signal via the optical output jack to an AV amplifier or receiver.

9DIGITAL OUTPUT COAXIAL jack [15]

Use to output the digital audio signal recorded on discs. You can output the digital signal via the coaxial output jack to an AV amplifier or receiver.

0z jack [15]

Use to connect this player to another component bearing the z mark. This lets you control this unit as though it were a component in a system.

-AC INLET [16]

Use to connect the power cord to the wall outlet.

11