Integra DPS-7.3 instruction manual Ir Out

Operating Components not Reached by the Remote Controller Signals (IR IN/OUT)

The following equipment (sold separately) is essential for operation:

•Integra/Onkyo’s Multi-Room System kits (IR Remote Controller Extension System), or

•Multiroom A/V distribution and control systems from Niles® and Xantech® to name a few.

If the remote controller signal does not reach the DPS-7.3 remote sensor

If the DPS-7.3 is located inside a cabinet or other enclosure where the infrared rays from the remote controller cannot enter, then operation with the remote controller will not be possible. In such a case, it will be necessary to install a remote sensor at a location outside of the cabinet for the infrared rays from the controller to reach.

If the remote controller signal does not reach other components

In this situation, you will need to use a commercially available IR emitter. Connect the mini plug of the IR emitter to the IR OUT terminal on the DPS-7.3 and then place the IR emitter on the remote sensor of the component or facing it. When the IR emitter is connected, only the signal input to the IR IN terminal is output to the IR OUT terminal. The signal input from the remote sensor on the front of the DPS-7.3 will not be output to the IR OUT terminal.

Connecting block

IR IN

IR Receiver

IR IN

IR Receiver

Connecting block

DPS-7.3

DPS-7.3

IR OUT

Remote Controller

In the cabinet

:Signal flow

Make connection as shown below. Do not plug the equipment into the power source until the connection is completed.

Mini plug cable

IR

OUT

from connecting block

IN

DPS-7.3

IR Emitter

Remote Controller

otther component

:Signal flow

otther component

:Signal flow

Remote control sensor

Emitter

Mini plug cable

	Mini plug
IR
OUT
IN	IR Emitter
DPS-7.3

61