Integra DPS-6.7 Connecting -compatible Components, Connecting the Multichannel Analog Output

DPS-6.7_En.book Page 23 Monday, July 31, 2006 3:12 PM

Connecting the DVD player—Continued

Connecting the Multichannel Analog Output

Connect the DVD player’s FRONT/D.MIX 1 or 2, SURR 1, CENTER, and SUBWOOFER jacks to the multichannel analog audio input on your AV receiver.

You can use three stereo audio cables for this.

Connecting -compatible Components

AUDIO OUTPUT

ANALOG

FRONT/D. MIX SURR1 CENTER

1 2

SUB

WOOFER

FRONT

RL

SUBCENTER

SURR

AV receiver

■If Your AV Receiver has a 7.1-channel Analog Audio Input

Connect the DVD player’s SURR 1 jacks to your AV receiver’s surround input jacks, and connect the SURR 2 jacks to your AV receiver’s surround back input jacks. The SURR 1 and SURR 2 outputs output the same signals.

When you make this connection, set the SURR MODE switch to “1+2.”

If you use this connection, the output level will be reduced by 3 dB (i.e., the volume level will be reduced slightly).

FRONT/D. MIX

REMOTE

CONTROL

1 2

IN

L

R

REMOTE

CONTROL

AV receiver

•The remote controller supplied with Integra/Onkyo AV receiver or amplifiers can be used to control the DVD player.

•The function of the upper and lower connectors are the same. Connect to either one.

•To use , in addition to an connection, you must also make an analog audio connection (RCA) between

the DVD player and your other -capable compo- nents.

23