Configuring the DVD player—Continued
Audio Menu
Digital/HDMI Audio Out
With this setting you can configure the optical, coaxial, and HDMI digital outputs.
All (default): Dolby Digital and DTS signals are out- put as they are.
PCM: Dolby Digital and DTS signals are down mixed to 2 channels and output as PCM.
Off: No digital signals are output.
Note:
■Subwoofer
On (default): Select if a subwoofer is connected.
Off: Select if no subwoofer is connected.
■Front Speaker
Large: Select if the front speakers are large.
Small (default): Select if the front speakers are small.
Note:
•If the Subwoofer setting is set to Off, this setting is fixed at Large and cannot be changed.
• MPEG is output as PCM regardless of this setting. | ■ Center Speaker | |
Linear PCM Out | Large: Select if the center speaker is large. | |
Small (default): Select if the center speaker is small. | ||
| ||
|
With this setting you can configure the DVD player to output digital audio with higher sampling rates (e.g.,
88.2kHz, 96 kHz) as it is or to down sample it to 48 kHz or below.
If the AV component you connect to the DVD player’s digital audio outputs supports 96 kHz digital audio, select Down Sample Off. Otherwise, select Down Sam- ple On.
Down Sample On: 196 kHz and 96 kHz sources are down sampled to 48 kHz, and 176.4 kHz and
88.2 kHz sources are down sampled to 44.1 kHz.
Down Sample Off (default): Sources are output as they are.
Notes:
•Some
96 kHz digital audio only for D/A conversion to the analog audio outputs.
•With some discs, even if you select Down Sample Off, the digital audio will be down sampled, and in some cases may not be output by the DVD player’s digital audio outputs.
Off: Select if no center speaker is connected.
Note:
•If the Front Speaker setting is set to Small, the Large option cannot be selected.
■Surround Speaker
Large: Select if the surround speakers are large.
Small (default): Select if the surround speakers are small.
Off: Select if no surround speakers are connected.
Note:
•If the Front Speaker setting is set to Small, the Large option cannot be selected.
Test Tone
If you can adjust the volume level of each channel of your amp’s multichannel input, with this function, you can output a test tone from each multichannel output jack in turn and adjust each level as necessary.
1.Use the Up/Down [
]/[ ] buttons to select a speaker, and then press the [Enter] button.
Speaker Configuration
With these settings, you can specify which speakers are connected and their sizes. These settings only apply to the DVD player’s analog multichannel output. If you connect to only the FRONT/D.MIX L/R jacks, set the Subwoofer, Center Speaker, and Surround Speaker set- tings to Off.
Note:
•The Speaker Configurations have no effect on 192 kHz/176.4 kHz
•To use the Speaker Configuration settings with SACD playback, in the SACD Audio Setup, select PCM.
A test tone is output by each speaker as it’s selected.
2.Refer to your AV receiver’s instruction manual for details on adjusting the volume level of each channel.
Note:
• The test tone is not output by the digital audio outputs.
48